Gateway AG-168V user manual Call when Pstn first Dual mode enabled

Page 37

AG-168V SIP GATEWAY User Manual (V1.42)

and then press .

￿Call when PSTN first Dual mode enabled

￿Call PSTN number

When PSTN first setted, the way of dial is the same as normal PSTN phone.

￿Call voip number

￿Press the cradle or the flash key of the normal phone, enable AG-168 to be in voip

state from pstn first mode. Dial after the dial tone. Refer to “Call when Dual mode

disabled” chaptor

￿Call when IP first Dual mode enabled

￿Dial voip phone

When ip first was setted , pick up the phone and dial as “Call when Dual mode

disabled”chaptor

￿Call PSTN phone

Predial the prefix number in the “dual mode prefix”, AG-168V will change to

PSTN line, call after the dial tone.

￿Emergency Call

When AG-168V is power off or in falure, the Normal phone would connect with the PSTN LINE, work as the “LIFELINE” and call emergency number.

37

Image 37
Contents Function Keys of AG-168V SIP Gateway Introduction Features Software HardwareOperating requirements Standard and ProtocolElectric requirements Gateway supports following standard and protocolSize InstallationPhone Keypad setup ConfigurationConfigured by WEB Is192.169.1.100 Network SettingPage Protocol Setting Page Register port  phone number set local IDPhone settings Page  inner line prefix default is Audio settings G729g7231g711ug711a and gsm Other settingsPhonenumber check phonenumber auto upgrade Button to confirm the modification Configured by PalmToolAG-168V Telnet Commands Explanation Telnet ConfigurationComman Command get Detail description of AG-168V Telnet commands Command ?Get SetInnerline 1enable Localprefix Detailed description Set iptype Command set Syntax description set keywords valueSet ppppin Set pppidSet ip Set subnetmaskSet service type Set serviceSet router Set dnsSet serviceid Set serviceaddrSet nattraversal Set nataddrSet natttl Set signalportSet GATEWAYnumber Set accountSet rtptos Set registerttlSet rtpport Set jittersizeSet dialplan Set dtmf payloadSet dialnumber Set dddcodeSet dddprefix Set iddprefixSet innerline Set localpreifxSet digitmap Set fwdpoweroffSet fwdnumber Set fwdalwaysSet vad Set 6.3kSet agc Set aecSet superpassword Set passwordSet codec2 Set codec3Command store Set upgradeaddrRelevant Usage store Command load Relevant Usage load Command exitFtp command Syntax description ftp value Command ping Syntax description ping IP addressRelevant usage ftp  Call with ip address Usage of AG-168V FXSCall when Pstn first Dual mode enabled Telnet command to updating Upgrade AG-168V IP GatewayUsing Http Prepare Updated program through FTPHardwareTagServiceTypeProtocolXXX.bin Ocheck.The configuration All rights reserved