Gateway AG-168V Set dtmf payload, Set dialplan, Set dialnumber, Set dddcode, Set iddcode

Page 29

AG-168V SIP GATEWAY User Manual (V1.42)

Set DTMF relay type. X is ranged form 0 through 3: 0:control string1:inband

audio2: signal keypad3:rfc 2833.

set dtmf payload X

When dtmf X select 3(rfc 2833).This parameter can be used indicating type of RTP payload type. The value can be use integer 96-101.

set dialplan X

Enable/disable dial plan and dial number. Parameter X ranged from 0

through 4: 0: disable dial plan; 1: enable dial plan; 2: use dial number; 3: use

179XX service.;4: use hotline function.

set dialnumber XX

When set dialplan value set as 2, please use this command to set dial

number. For example, with eTalk card used, please set it as 00. When set

dialplan value set as 4, please use this command to set hotline number.

set dddcode XX

Set the area code when set dialplan value set as 1 or 2. For example, the

area code of Beijing is 10; the area code of Shanghai is 21, and the area

code of Chengdu is 28, etc. Parameter xxx must be an Arabic numeral and

no longer than 3 characters.

set iddcode XXX

Set the country code when set dialplan value set as 1 or 2. For example, the

country code of China is 86; the country code of USA is 1, etc. Parameter

xxxx must be an Arabic numeral and no longer than 4 characters.

29

Image 29
Contents Function Keys of AG-168V SIP Gateway Introduction Features Software HardwareOperating requirements Standard and ProtocolElectric requirements Gateway supports following standard and protocolSize InstallationPhone Keypad setup ConfigurationConfigured by WEB Is192.169.1.100 Network SettingPage Protocol Setting Page Register port  phone number set local IDPhone settings Page  inner line prefix default is Audio settings G729g7231g711ug711a and gsm Other settingsPhonenumber check phonenumber auto upgrade Button to confirm the modification Configured by PalmToolComman Telnet ConfigurationAG-168V Telnet Commands Explanation Command get Detail description of AG-168V Telnet commands Command ?Get SetInnerline 1enable Localprefix Detailed description Set iptype Command set Syntax description set keywords valueSet ppppin Set pppidSet ip Set subnetmaskSet service type Set serviceSet router Set dnsSet serviceid Set serviceaddrSet nattraversal Set nataddrSet natttl Set signalportSet GATEWAYnumber Set accountSet rtptos Set registerttlSet rtpport Set jittersizeSet dialplan Set dtmf payloadSet dialnumber Set dddcodeSet dddprefix Set iddprefixSet innerline Set localpreifxSet digitmap Set fwdpoweroffSet fwdnumber Set fwdalwaysSet vad Set 6.3kSet agc Set aecSet superpassword Set passwordSet codec2 Set codec3Command store Set upgradeaddrRelevant Usage store Command load Relevant Usage load Command exitRelevant usage ftp Command ping Syntax description ping IP addressFtp command Syntax description ftp value  Call with ip address Usage of AG-168V FXSCall when Pstn first Dual mode enabled Telnet command to updating Upgrade AG-168V IP GatewayUsing Http Prepare Updated program through FTPHardwareTagServiceTypeProtocolXXX.bin Ocheck.The configuration All rights reserved