BT Diverse 2010 manual If the symbol flashes

Page 12

If the symbol flashes

continuously, it means the handset is either out of range or is not registered with the base station. To register, follow the steps on page 26. All additional handsets you purchase will need to be individually registered with the base station before they will work with the Diverse 2010.

The symbol may also flash after a power failure. Provided the handset has been registered with the base, the symbol will stop flashing after a while indicating the handset has automatically re-registered to the base station. If it continues to flash, re- register the handset to the base station.

Please note: If you go out of range of a base station for a long time while your handset is switched ON, it may take more than 20 minutes to ÔfindÕ the base station again when you come back within range. However, by simply switching the handset OFF for a moment, then ON again, it will find the base station within a few seconds.

9

Image 12

Contents Diverse For your records Base Station PIN Number Handset PIN NumberAt a glance INTDiverse Base station underside view Power cord Telephone Line cord This guide Hints and tips boxesIntroducing the Diverse Building up a phone systemSetting up General cleaningFollow these steps to get your Diverse 2010 ready for use Connect the power cable Install the rechargeable batteries in the handset Fit the handset Belt clipBattery display when inserting or replacing a battery Battery performanceBattery low warning Getting the most out of your batteriesIf the symbol flashes Using your Diverse To switch to Protected when Handset is onOn/Off and Protected modes Call timer To make an external callTo end a call To receive an external callTo page a handset from the base station To make an internal intercom call to Another handsetTo receive an internal call To make an internal call to all HandsetsTo transfer an external call between Handsets Quick call transferTo store a number To speed dial a number stored on MemoryTo clear all the numbers stored on a Handset’s memory Additional features Setting to Tone or Pulse diallingSecurity code and handset PIN To change a system code for Diverse 2010 base stationAdjusting volumes and tones To adjust the ringer volume HandsetAdjusting the ear piece volume To adjust the tone of the handsetTo adjust the ringer volume Base station To adjust the tone of the base station Ringer‘Confirmation’ tones ‘Wrong key’ tone‘Settings confirmation’ tone Battery warning tone‘Range warning’ tone ‘In-range’ toneTo reset your Diverse 2010 handset to the original settings Secrecy Call allocationTo set which handset will receive ring Priority To set the number of rings on ring PriorityTo add and remove handsets that Respond to group ringing To cancel your own ‘special numbers’ Call barringTo store your own ‘special numbers’ Using your Diverse 2010 with a switchboard Entering access codesTo insert an access code Setting the access pause At the base station To register a handsetPlease Note To remove a handset registered at Base stationHow to set up multiple base stations and handsets Operating with additional base stationsTo set/clear the base station number Display from a handset To set your handset for automatic base selectionSTO INT Maintenance ServiceWithin the warranty period Outside the warranty periodHelp Emergency callsReplacing handset batteries When connected to a switchboard If the power fails Technical informationEnvironment ApprovalTechnical specification Index RENOffices in Europe, North America, Japan and Asia Pacific 504116