BT Diverse 2010 Install the rechargeable batteries in the handset, Fit the handset Belt clip

Page 10

4 Plug your Diverse 2010

2

into the phone socket

1

If you do not have a modern phone socket, call Freefone 0800 800 150 and ask for a BT engineer to come and fit the correct socket. This is a chargeable service.

WARNING

It is recommended that the line cord is not connected until the handset is fully charged. This will prevent the risk of the phone being answered prior to the batteries being fully charged and therefore not achieving their optimum capacity.

5Install the rechargeable batteries in the handset

The handset uses the two AA size nickel cadmium (NiCad) batteries, which are supplied. To install them, insert the batteries as indicated on the label inside the battery compartment and slide the battery compartment cover shut.

The battery compartment cover may be found in the packaging with the batteries.

Important

When replacing batteries always use good quality nickel cadmium (NiCad) rechargeable AA types with at least 600mAh capacity in order to achieve the specified operating time. Never use other batteries or conventional alkaline batteries. They could result in a short circuit or destroy the battery casing. Recommended rechargeable batteries are available from the Diverse Helpline 0345 908070 and the BT Shop.

6 Fit the handset Belt clip

Fit the belt clip onto the back of the handset.

Tab

Slot

7

Image 10
Contents Diverse For your records Base Station PIN Number Handset PIN NumberAt a glance INTDiverse Base station underside view Power cord Telephone Line cord This guide Hints and tips boxesIntroducing the Diverse Building up a phone systemGeneral cleaning Setting upFollow these steps to get your Diverse 2010 ready for use Connect the power cable Install the rechargeable batteries in the handset Fit the handset Belt clipBattery low warning Battery display when inserting or replacing a batteryBattery performance Getting the most out of your batteriesIf the symbol flashes To switch to Protected when Handset is on Using your DiverseOn/Off and Protected modes To end a call Call timerTo make an external call To receive an external callTo receive an internal call To page a handset from the base stationTo make an internal intercom call to Another handset To make an internal call to all HandsetsTo transfer an external call between Handsets Quick call transferTo speed dial a number stored on Memory To store a numberTo clear all the numbers stored on a Handset’s memory Additional features Setting to Tone or Pulse diallingSecurity code and handset PIN To change a system code for Diverse 2010 base stationAdjusting the ear piece volume Adjusting volumes and tonesTo adjust the ringer volume Handset To adjust the tone of the handset‘Confirmation’ tones To adjust the ringer volume Base stationTo adjust the tone of the base station Ringer ‘Wrong key’ tone‘Range warning’ tone ‘Settings confirmation’ toneBattery warning tone ‘In-range’ toneTo reset your Diverse 2010 handset to the original settings Secrecy Call allocationTo set the number of rings on ring Priority To set which handset will receive ring PriorityTo add and remove handsets that Respond to group ringing Call barring To cancel your own ‘special numbers’To store your own ‘special numbers’ Entering access codes Using your Diverse 2010 with a switchboardTo insert an access code Setting the access pause At the base station To register a handsetPlease Note To remove a handset registered at Base stationHow to set up multiple base stations and handsets Operating with additional base stationsTo set/clear the base station number Display from a handset To set your handset for automatic base selectionSTO INT Within the warranty period MaintenanceService Outside the warranty periodEmergency calls HelpReplacing handset batteries When connected to a switchboard Environment If the power failsTechnical information ApprovalTechnical specification Index RENOffices in Europe, North America, Japan and Asia Pacific 504116