BT Diverse 2010 manual Using your Diverse, On/Off and Protected modes

Page 13

Using your Diverse 2010

On/Off and Protected modes

The handset can be set to one of three different modes. Your handset’s display will indicate which mode it is currently in, as shown below.

OFF

Phone calls cannot be made and the handset does not respond to incoming calls. Nothing is shown on the display.

To switch on, press and hold down the PWR button until the display is activated.

ON

You can make and receive calls.

PROTECTED

The setting stops you accidentally operating the handset’s keypad when carrying it around. You can still receive incoming calls but you cannot make outgoing calls.

To switch to PROTECTED when the

handset is ON

PWR

•Press and release the PWR button.

If the handset is beyond radio distance of the base station, the symbol flashes. You cannot make or receive calls until the handset is brought back within range. The symbol also flashes for a while after power-up until the handset automatically registers to the base.

	To switch off, press and hold down the	• Press and release the PWR button
	PWR button until the display goes blank.
		again to switch off protected mode.

10

Image 13

Contents Diverse Base Station PIN Number Handset PIN Number For your recordsINT At a glanceDiverse Base station underside view Power cord Telephone Line cord Hints and tips boxes This guideBuilding up a phone system Introducing the DiverseGeneral cleaning Setting upFollow these steps to get your Diverse 2010 ready for use Connect the power cable Fit the handset Belt clip Install the rechargeable batteries in the handsetBattery performance Battery display when inserting or replacing a batteryBattery low warning Getting the most out of your batteriesIf the symbol flashes To switch to Protected when Handset is on Using your DiverseOn/Off and Protected modes To make an external call Call timerTo end a call To receive an external callTo make an internal intercom call to Another handset To page a handset from the base stationTo receive an internal call To make an internal call to all HandsetsQuick call transfer To transfer an external call between HandsetsTo speed dial a number stored on Memory To store a numberTo clear all the numbers stored on a Handset’s memory Setting to Tone or Pulse dialling Additional featuresTo change a system code for Diverse 2010 base station Security code and handset PINTo adjust the ringer volume Handset Adjusting volumes and tonesAdjusting the ear piece volume To adjust the tone of the handsetTo adjust the tone of the base station Ringer To adjust the ringer volume Base station‘Confirmation’ tones ‘Wrong key’ toneBattery warning tone ‘Settings confirmation’ tone‘Range warning’ tone ‘In-range’ toneTo reset your Diverse 2010 handset to the original settings Call allocation SecrecyTo set the number of rings on ring Priority To set which handset will receive ring PriorityTo add and remove handsets that Respond to group ringing Call barring To cancel your own ‘special numbers’To store your own ‘special numbers’ Entering access codes Using your Diverse 2010 with a switchboardTo insert an access code Setting the access pause To register a handset At the base stationTo remove a handset registered at Base station Please NoteOperating with additional base stations How to set up multiple base stations and handsetsTo set your handset for automatic base selection To set/clear the base station number Display from a handsetSTO INT Service MaintenanceWithin the warranty period Outside the warranty periodEmergency calls HelpReplacing handset batteries When connected to a switchboard Technical information If the power failsEnvironment ApprovalTechnical specification REN Index504116 Offices in Europe, North America, Japan and Asia Pacific