BT Diverse 2010 manual Connect the power cable

Page 9

Plan where you will put your Diverse 2010. It should be within two metres of a power socket and the phone socket.

1. Connect the power cable.

Plug the power cable into the power socket on the underside of your Diverse 2010. Take care that the telephone line cord and power cable plugs are connected to the correct sockets. Incorrect placement could damage the station.

2.Plug the 3 pin adaptor into a mains power socket and switch on.

3.Connect the telephone line cord to the Diverse 2010 base station.

Ensure that this is fitted correctly into the right socket.

. . . .

. . . .

. . . .

. . . .

.

Use only the power adaptor

C39 280 -Z4 -C67 with your Diverse 2010.

6

Image 9

Contents Diverse Base Station PIN Number Handset PIN Number For your recordsINT At a glanceDiverse Base station underside view Power cord Telephone Line cord Hints and tips boxes This guideBuilding up a phone system Introducing the DiverseSetting up General cleaningFollow these steps to get your Diverse 2010 ready for use Connect the power cable Fit the handset Belt clip Install the rechargeable batteries in the handsetBattery performance Battery display when inserting or replacing a batteryBattery low warning Getting the most out of your batteriesIf the symbol flashes Using your Diverse To switch to Protected when Handset is onOn/Off and Protected modes To make an external call Call timerTo end a call To receive an external callTo make an internal intercom call to Another handset To page a handset from the base stationTo receive an internal call To make an internal call to all HandsetsQuick call transfer To transfer an external call between HandsetsTo store a number To speed dial a number stored on MemoryTo clear all the numbers stored on a Handset’s memory Setting to Tone or Pulse dialling Additional featuresTo change a system code for Diverse 2010 base station Security code and handset PINTo adjust the ringer volume Handset Adjusting volumes and tonesAdjusting the ear piece volume To adjust the tone of the handsetTo adjust the tone of the base station Ringer To adjust the ringer volume Base station‘Confirmation’ tones ‘Wrong key’ toneBattery warning tone ‘Settings confirmation’ tone‘Range warning’ tone ‘In-range’ toneTo reset your Diverse 2010 handset to the original settings Call allocation SecrecyTo set which handset will receive ring Priority To set the number of rings on ring PriorityTo add and remove handsets that Respond to group ringing To cancel your own ‘special numbers’ Call barringTo store your own ‘special numbers’ Using your Diverse 2010 with a switchboard Entering access codesTo insert an access code Setting the access pause To register a handset At the base stationTo remove a handset registered at Base station Please NoteOperating with additional base stations How to set up multiple base stations and handsetsTo set your handset for automatic base selection To set/clear the base station number Display from a handsetSTO INT Service MaintenanceWithin the warranty period Outside the warranty periodHelp Emergency callsReplacing handset batteries When connected to a switchboard Technical information If the power failsEnvironment ApprovalTechnical specification REN Index504116 Offices in Europe, North America, Japan and Asia Pacific