BT Diverse 2010 manual Help, Emergency calls, Replacing handset batteries

Page 35

Help

Your Diverse 2010 has been designed to be easy to use. If you should experience a problem, please check the following points before calling the Diverse Helpdesk.

Emergency calls

The emergency services can be contacted in the UK by dialling 999, or 112 in any country that is a member of the European Community.

If your Diverse 2010 is connected to a switchboard, you may have to dial an access number before 999 to contact the emergency services. Some switchboards cannot dial out during a power failure.

Under ideal conditions, the handset batteries should give about 7 hours talktime or 60 hours standby on a single charge (both standby and talk time is reduced for the Diverse 2000 Executive Handset to approximately 50 hours standby and 6 hours talktime). However, new NiCad batteries do not reach their full capacity until they have been in normal use for several days.

Please note that the lifespan of NiCad rechargeable batteries depends on how heavily they are used. However, over time, their capacity to recharge will begin to diminish and they will eventually need replacing.

Fully charged batteries do not indicate full power when put into a handset

When you replace handset batteries with ones that have been fully charged, the battery indicator will not show full until the next charge cycle has been completed. Charge the handset until the batteries register full again. From then on the display will be correct.

Battery performance

After charging your Diverse 2010 for the first time, subsequent charging time for the handset batteries is approximately 4-5 hours. Batteries and case may become warm during charging. This is normal and not dangerous.

Replacing handset batteries

After a time, you may find that the handset batteries are running out of charge more quickly. This is a standard sign of wear and the batteries will need replacing.

Use only AA size, approved rechargeable batteries in the handset. Any other types may cause irreparable damage. Never use conventional alkaline batteries. For a list of approved batteries, see page 5. Batteries are available from the Diverse Helpline on 0345 908070 or your local BT shop.

Do not immerse batteries in water or throw them into fire, or dispose of them with ordinary domestic refuse. To charge the batteries place the handset on its base station.

32

Page 34 Page 36
Image 35
Page 34 Page 36
Contents Diverse Base Station PIN Number Handset PIN Number For your recordsINT At a glanceDiverse Base station underside view Power cord Telephone Line cord Hints and tips boxes This guideBuilding up a phone system Introducing the DiverseFollow these steps to get your Diverse 2010 ready for use Setting upGeneral cleaning Connect the power cable Fit the handset Belt clip Install the rechargeable batteries in the handsetGetting the most out of your batteries Battery display when inserting or replacing a batteryBattery performance Battery low warningIf the symbol flashes On/Off and Protected modes Using your DiverseTo switch to Protected when Handset is on To receive an external call Call timerTo make an external call To end a callTo make an internal call to all Handsets To page a handset from the base stationTo make an internal intercom call to Another handset To receive an internal callQuick call transfer To transfer an external call between HandsetsTo clear all the numbers stored on a Handset’s memory To store a numberTo speed dial a number stored on Memory Setting to Tone or Pulse dialling Additional featuresTo change a system code for Diverse 2010 base station Security code and handset PINTo adjust the tone of the handset Adjusting volumes and tonesTo adjust the ringer volume Handset Adjusting the ear piece volume‘Wrong key’ tone To adjust the ringer volume Base stationTo adjust the tone of the base station Ringer ‘Confirmation’ tones‘In-range’ tone ‘Settings confirmation’ toneBattery warning tone ‘Range warning’ toneTo reset your Diverse 2010 handset to the original settings Call allocation SecrecyTo add and remove handsets that Respond to group ringing To set which handset will receive ring PriorityTo set the number of rings on ring Priority To store your own ‘special numbers’ To cancel your own ‘special numbers’Call barring To insert an access code Using your Diverse 2010 with a switchboardEntering access codes Setting the access pause To register a handset At the base stationTo remove a handset registered at Base station Please NoteOperating with additional base stations How to set up multiple base stations and handsetsTo set your handset for automatic base selection To set/clear the base station number Display from a handsetSTO INT Outside the warranty period MaintenanceService Within the warranty periodReplacing handset batteries HelpEmergency calls When connected to a switchboard Approval If the power failsTechnical information EnvironmentTechnical specification REN Index504116 Offices in Europe, North America, Japan and Asia Pacific
Top Page Image Contents