Getting Started
E
DESKTOP INSTALLATION
Follow these instructions to place the base on a desk or table top using the supplied bracket.
1.Insert the bracket’s tab into the base’s upper tab slots in the direction of DESKTOP marked on the bracket, then press down on the bracket’s clips and insert them into the clip slots.
2.Plug one end of the supplied modular telephone line cord into the TEL jack located on the back of the base of the phone.
7.Lift the base’s antenna to a vertical position.
8.Set the TONE/PULSE switch located on the back of the base to correct dialing mode. Please check with your local Phone Company if uncertain of the type of service.
9.Place handset in the cradle to begin initial charging. Remember, you must charge the phone for at least 12 hours before you use the phone for the first time.
N G L I S H
3.Plug the modular telephone line cord’s other end into a modular phone jack.
4.Insert the supplied AC adapter’s plug into the jack marked DC 9V 500mA located on the back of the telephone base.
5.Route the adapter’s cord through the strain relief slot on the bracket.
USE ONLY WITH CLASS TWO POWER SOURCE |
|
| |
PULSE/TONE | BOOST | DC 9V | TEL |
| ON/OFF | 500mA |
|
|
|
| |
6.Plug the adapter into a standard AC power (electrical) outlet.
11