VTech CS5121-3, CS5121-2, CS5122-3, CS5121-4 Set telephone base ringer, Set remote access code

Answering system

Set telephone base ringer

This feature allows you to select the telephone base ringer volume level.

1.Press SET UP when in idle mode until the system announces the telephone base ringer setting. There are three levels: HI (high), OF (off) and LO (low).

2.Press /SKIP or /REPEAT until the system announces the desired telephone base ringer volume level, then press SET UP to save the setting and go to the next setting, or press /PLAY/STOP to save and return to the idle mode.

Set remote access code

A two-digit security code is required to access the answering system from any touch tone telephone. The preset code is 19. You can set the remote access code from 10 to 99.

To set the remote access code:

1.Press SET UP when in idle mode until the system announces the remote access code setting.

2.Press /SKIP or /REPEAT to change the remote access code by one, or press and hold /SKIP or /REPEAT to change it by increments of ten. Press SET UP to save the setting and go to the next setting, or press /PLAY/STOP to save and return to the idle mode.

•The handset ringer volume is set separately. See page 9 for details.

Basic operationAnswering system

www.vtechphones.com 35