VTech CS5122-3, CS5121-2, CS5121-3, CS5121-4 important safety instructions Battery

Page 49

Battery

After the battery is fully charged for 16 hours, you can expect the following performance:

 

Operation

Operating time

 

 

 

 

While in use (talking)

Five hours

 

 

 

 

While not in use (standby*)

Six days

 

 

 

*Handset is off the telephone base but not in use.

 

The battery needs charging when:

 

A new battery is installed in the handset.

The handset beeps.

LOW BATTERY is displayed and the battery indicator on the handset screen is flashing.

CAUTION:

To reduce the risk of fire or injury to persons, read and follow these instructions:

Use only the battery(ies) provided or equivalent. To order a replacement, visit our website at www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call 1 (800) 267-7377.

Do not dispose of the battery(ies) in a fire. Check with local waste management codes for special disposal instructions.

Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed.

Exercise care in handling batteries in order not to create a short circuit with conductive materials such as rings, bracelets, and keys. The battery and/or conductor may overheat and cause burns.

Charge the battery(ies) provided with or identified for use with this product only in accordance with the instructions and limitations specified in this manual.

WARNING:

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT TO WATER OR ANY TYPE OF MOISTURE.

46

www.vtechphones.com

Image 49
Contents Congratulations Important safety instructionsTable of contents Appendix Getting started Parts checklistTelephone base and chargers installation Battery installation and charging Wall mounting bracket installation Mounting bracket installationDesktop/tabletop bracket installation VOL-/CID Handset layoutDelete Telephone base layoutDate and time Telephone settingsRinger Ringer volume handsetHome area code Dial modeLanguage Telephone operation Temporary tone dialing Call waitingFind handset RedialTransfer an external call Store a directory entry DirectoryReview the directory Character chartDirectory Edit a directory entryDelete a directory entry Dial a number from the directory Copy a directory entry into speed dialStore a speed dial entry Speed dialEdit a speed dial entry Dial a speed dial number Delete a speed dial entryReassign speed dial locations About caller ID Call log Make call log entries ready to dial Review the call logDial a call log number Entries ready to dial section on Save a call log entry to the directoryDelete an entry Delete from the call logDisplays When Call log display screen messagesMessage capacity Answering systemSet the clock Activate the answering systemSet number of rings Answering system setupSet telephone base ringer Set remote access codeSet message alert tone Play your announcement Outgoing announcementDelete your announcement Record your own announcementMessage playback New message indicationOptions during playback Record and play memos Delete all messagesRecord a memo Memo playbackCall intercept Call screeningWindow displays When Message window displaysCommand Function Remote accessHandset display screen messages Appendix Battery Important safety instructions Problem Suggestion TroubleshootingAppendix Connecting To take place Your area. See Dial mode on page 10 to set the dial type Telephone company charges may apply Remove and re-insert the battery System does Troubleshooting Troubleshooting Operating range MaintenanceAbout cordless telephones WarrantyHow do you get warranty service? FCC Part FCC, Acta and IC regulationsRbrc seal Technical specifications Index Transfer an external call  91-002141-010-100 User’s manual