2410 and 5410 User Guide
Longhand Programming
2. Press 
Admin or 
Admin 1. See Display Key Programming.
2. To switch to longhand programming mode, press Expl? 
.
2. Press Next 
until the required function required is shown, then press Selct 
.
2.If the function requires some data to be entered, [ ] is shown at the bottom of the display. Enter the data using the normal telephone keypad.
2.The upper part of the display reverts to showing the functions currently assigned to each 
and 
.
2. To move between the pages of display keys, press 
and 
.
2.To select the display key against which to program the new function, press 
or 
.
Caution
Do not select the slot used for the Admin function. Replacing this function will lock the phone for further programming until reset through the telephone system.
2.If the display slot is not already used, the display shows BUTTON PROGRAMMED!.
∙To end programming, press 
Exit.
∙To continue programming other functions, press 
Cont.
9.If the display slot already has a programmed function, the display shows FEATURE ON BUTTON. Press 
or 
until Repla, Keep and Delet are shown along the
∙Press Repla 
to replace that existing function with the one just programmed. BUTTON PROGRAMMED! is displayed.
∙To keep the existing function and forget the function just programmed, press Keep 
.
∙To delete the existing function and forget the function just programmed, press Delete 
.
2410 and 5410 User Guide | Page 30 |
IP Office 3.2 |