Error Messages
Reports!
If your unit cannot send a fax, check the following.
–The number you dialled is correct.
–The other party’s machine is a facsimile.
If the problem remains, correct it by following the communication message printed on the sending and journal reports (p. 32).
Communication message | Error | Cause & Remedy | ||
code | ||||
|
|
| ||
COMMUNICATION ERROR | ● A transmission or reception error occurred. Try | |||
|
| again or check with the other party. | ||
|
| 58, 65 |
| |
|
| 68, 72 |
| |
|
| FF |
| |
|
|
|
| |
|
| 43 | ● An overseas transmission error occurred. Try using | |
|
| 44 | the overseas mode (feature #23 on page 67). | |
|
|
|
| |
DOCUMENT JAMMED | — | ● The document is jammed. Remove the jammed | ||
|
|
| document (p. 81). | |
|
|
|
| |
| 54 | ● A transmission or reception error occurred | ||
|
| 59 | because of a problem with the other party’s fax | |
|
| 70 | machine. Check with the other party. | |
|
|
|
| |
MEMORY FULL | — | ● The document was not received due to memory | ||
|
|
| being full. | |
|
|
|
| |
NO DOCUMENT | — | ● The document was not fed into the unit properly. | ||
|
|
| Reinsert the document and try again. | |
|
|
|
| |
OTHER FAX NOT RESPOND | — | ● The other party’s fax machine is busy or has run | ||
|
|
| out of recording paper. Try again. | |
|
|
| ● The document was not fed properly. Reinsert the | |
|
|
| document and try again. | |
|
|
| ● The other party’s fax machine rings too many | |
|
|
| times. Send a fax manually – dial the number, | |
|
|
| confirm the fax tone, and press FAX START . | |
|
|
| ● The other party’s machine is not a facsimile. | |
|
|
| Check with the other party. | |
|
|
| ● The number you dialled is not in service. | |
|
|
|
| |
PRESSED THE STOP KEY | — | ● STOP was pressed and fax communication was | ||
|
|
| cancelled. | |
|
|
|
| |
THE COVER WAS OPENED | — | ● The covers were opened. Close them and try | ||
|
|
| again. |
OK
—
●Fax communication was successful.
72