Kenwood TK-3230 instruction manual Preparation, Battery Pack Precautions

Page 13

Preparation

Battery Pack Precautions

Do not use battery packs or battery chargers not recommended by Kenwood.

◆Do not recharge the battery pack if it is already fully charged. Doing so may cause the lifespan of the battery pack to shorten or the battery pack may be damaged.

◆After charging the battery pack, disconnect it from the charger. If the charger power is reset (turned ON after being turned OFF), recharging will start again and the battery pack will become overcharged.

◆Do not use the transceiver while charging the battery pack. We recommend you switch the transceiver power OFF while charging is taking place.

◆Do not charge the battery pack when the battery pack or transceiver is wet, so as to avoid the risk of fire or damage.

Wipe the water from the battery pack or transceiver using a dry cloth before charging.

◆Do not short the battery terminals or dispose of the battery by fire.

◆Never attempt to remove the casing from the battery pack.

Image 13

Contents TK-3230 Thank You FeaturesOperating Conditions Channel Spacing FCC License InformationFCC Warning IiiSafety Information Precautions Page Contents Viii Unpacking and Checking Equipment Supplied AccessoriesPart Number Quantity Power switch Antenna LED Indicator Menu keyVolume control PTT Push to Talk switchDisplay Icon DescriptionPreparation Battery Pack PrecautionsDo not disassemble or reconstruct battery Information concerning the Li-ion battery packDo not short-circuit the battery Do not incinerate or apply heat to the batteryDo not jar or throw the battery Do not touch a ruptured and leaking battery Do not reverse-charge or reverse-connect the batteryUsing the Li-ion Battery Pack Installing/ Removing the Battery Pack Charging the Battery Pack Installing/ Removing the Belt Clip Installing/ Removing Optional Accessories Adjust the Volume Switch the Power onGetting Started Select a ChannelMake a Call Channel frequency setup Press the or key to select your desired value Quiet Talk/ Digital Quiet TalkScanning the Channels Revert Channel Squelch Level Monitoring a ChannelVOX Operation Voice Activated Control VOXVOX Gain Level VOX Delay Time Transmit Inhibit While Receiving VOX Proceed Tone Privacy Talk Call Key Setup Call Alert Tone Call Alert Side Tone Selcall Selective Calling Press the PTT switch to transmit the selected selcall IDReceiving a Selcall PTT ID Mute Hold Time Caller ID Display Transmit Power Operating featuresKey Lock CompanderDisplay Backlight Super LockMic Sense Time-out Timer Battery Saver Battery Level Indicator Incoming Call Notification Beep Tone Busy Channel Lockout BCLMode Reset Timer Press the Menu key then press or to select a Call ID type ID List SEtting ModeResetting the Transceiver Optional Accessories Menus Name Settings Default Ref. PgOFF/ 5 500 Mute Hold Time 1000/ 15 Display QT Freq QT tones/ DQT codesDisplay DQT Code Display DQT Code Display DQT Code Channel Frequencies SetupNumber MHz Specifications Problem Solution Troubleshooting Guide