Kenwood TK-3230 instruction manual Charging the Battery Pack

Page 19

Charging the Battery Pack

Initial charging of the battery pack after purchase or extended storage (greater than 2 months) will not bring the battery pack to its normal operating capacity. After repeating the charge/ discharge cycle two or three times, the operating capacity will increase to normal.

Do not recharge the battery pack if it is already fully charged. Doing so may cause the life of the battery pack to shorten or the battery pack may be damaged.

After recharging the battery pack, disconnect it from the charger. Charging the battery pack for more than 5 days may reduce the battery pack life due to overcharging.

Note:

The ambient temperature should be between 41°F and 104°F (5°C and 40°C) while charging is in progress. Charging outside this range may not fully charge the battery.

Always switch OFF the transceiver equipped with a battery pack before charging. Using the transceiver while charging its battery pack will interfere with correct charging.

The battery pack life is over when its operating time decreases even though it is fully and correctly charged. Replace the battery pack.

1 Plug the AC adapter cable into the adapter jack located on the rear of the charger.

2 Plug the AC adapter into an AC outlet.

10

Image 19
Contents TK-3230 Thank You FeaturesOperating Conditions Channel Spacing FCC License InformationFCC Warning IiiSafety Information Precautions Page Contents Viii Unpacking and Checking Equipment Supplied AccessoriesPart Number Quantity PTT Push to Talk switch Antenna LED Indicator Menu keyPower switch Volume controlDisplay Icon DescriptionPreparation Battery Pack PrecautionsDo not incinerate or apply heat to the battery Information concerning the Li-ion battery packDo not disassemble or reconstruct battery Do not short-circuit the batteryDo not jar or throw the battery Do not touch a ruptured and leaking battery Do not reverse-charge or reverse-connect the batteryUsing the Li-ion Battery Pack Installing/ Removing the Battery Pack Charging the Battery Pack Installing/ Removing the Belt Clip Installing/ Removing Optional Accessories Select a Channel Switch the Power onAdjust the Volume Getting StartedMake a Call Channel frequency setup Press the or key to select your desired value Quiet Talk/ Digital Quiet TalkScanning the Channels Revert Channel Squelch Level Monitoring a ChannelVOX Operation Voice Activated Control VOXVOX Gain Level VOX Delay Time Transmit Inhibit While Receiving VOX Proceed Tone Privacy Talk Call Key Setup Call Alert Tone Call Alert Side Tone Selcall Selective Calling Press the PTT switch to transmit the selected selcall IDReceiving a Selcall PTT ID Mute Hold Time Caller ID Display Transmit Power Operating featuresKey Lock CompanderDisplay Backlight Super LockMic Sense Time-out Timer Battery Saver Battery Level Indicator Incoming Call Notification Beep Tone Busy Channel Lockout BCLMode Reset Timer Press the Menu key then press or to select a Call ID type ID List SEtting ModeResetting the Transceiver Optional Accessories Menus Name Settings Default Ref. PgOFF/ 5 500 Mute Hold Time 1000/ 15 Display QT Freq QT tones/ DQT codesDisplay DQT Code Display DQT Code Display DQT Code Channel Frequencies SetupNumber MHz Specifications Problem Solution Troubleshooting Guide