Kenwood TK-3230 instruction manual Press the PTT switch to transmit the selected selcall ID

Page 37

Selcall (Selective Calling)

A Selcall is a voice call to a particular station or group of stations. Each transceiver is set up with an individual ID number for use with selcalls.

nMaking a Selcall

1Press the CAL key.

2Press the or key to select an ID number.

•“ ” represents a single station, “ ” represents a group of stations, and “ ” represents all stations.

3Press the PTT switch to transmit the selected selcall ID.

•The transceiver waits for the Data Transmit Modulation Delay time {page 29} before transmitting the selcall ID.

•The side tone sounds if PTT ID side tone {page 30} is enabled.

4Release the PTT switch to end transmission.

5Press the CAL key to return to operating mode.

Note: If Optional Signaling (menu “ ”) has been set to “ ” (FleetSync), you can also set up an Individual Selcall Alert type (menu “ ”) and Group Selcall Alert type (menu “ ”). Individual and Group Selcall Alert types range from “ ” (off) and “ ” (type 1) to “ ” (type 10). Refer to the menu list on page 46.

28

Image 37

Contents TK-3230 Thank You FeaturesOperating Conditions Channel Spacing FCC License InformationFCC Warning IiiSafety Information Precautions Page Contents Viii Unpacking and Checking Equipment Supplied AccessoriesPart Number Quantity Power switch Antenna LED Indicator Menu keyVolume control PTT Push to Talk switchDisplay Icon DescriptionPreparation Battery Pack PrecautionsDo not disassemble or reconstruct battery Information concerning the Li-ion battery packDo not short-circuit the battery Do not incinerate or apply heat to the batteryDo not jar or throw the battery Do not touch a ruptured and leaking battery Do not reverse-charge or reverse-connect the batteryUsing the Li-ion Battery Pack Installing/ Removing the Battery Pack Charging the Battery Pack Installing/ Removing the Belt Clip Installing/ Removing Optional Accessories Adjust the Volume Switch the Power onGetting Started Select a ChannelMake a Call Channel frequency setup Press the or key to select your desired value Quiet Talk/ Digital Quiet TalkScanning the Channels Revert Channel Squelch Level Monitoring a ChannelVOX Operation Voice Activated Control VOXVOX Gain Level VOX Delay Time Transmit Inhibit While Receiving VOX Proceed Tone Privacy Talk Call Key Setup Call Alert Tone Call Alert Side Tone Selcall Selective Calling Press the PTT switch to transmit the selected selcall IDReceiving a Selcall PTT ID Mute Hold Time Caller ID Display Transmit Power Operating featuresKey Lock CompanderDisplay Backlight Super LockMic Sense Time-out Timer Battery Saver Battery Level Indicator Incoming Call Notification Beep Tone Busy Channel Lockout BCLMode Reset Timer Press the Menu key then press or to select a Call ID type ID List SEtting ModeResetting the Transceiver Optional Accessories Menus Name Settings Default Ref. PgOFF/ 5 500 Mute Hold Time 1000/ 15 Display QT Freq QT tones/ DQT codesDisplay DQT Code Display DQT Code Display DQT Code Channel Frequencies SetupNumber MHz Specifications Problem Solution Troubleshooting Guide