Kenwood TK-3230 instruction manual Do not jar or throw the battery

Page 15

DANGER

Do not charge the battery near fires or under direct sunlight!

If the battery’s protection circuit is damaged, the battery may charge at extreme current (or voltage) and an abnormal chemical reaction may occur. The battery may generate heat or smoke, rupture, or burst into flame.

Use only the specified charger and observe charging requirements!

If the battery is charged in unspecified conditions (under high temperature over the regulated value, excessive high voltage or current over regulated value, or with a remodelled charger), it may overcharge or an abnormal chemical reaction may occur. The battery may generate heat or smoke, rupture, or burst into flame.

Do not pierce the battery with any object, strike it with an instrument, or step on it!

This may break or deform the battery, causing a short-circuit. The battery may generate heat or smoke, rupture, or burst into flame.

Do not jar or throw the battery!

An impact may cause the battery to leak, generate heat or smoke, rupture, and/or burst into flame. If the battery’s protection circuit is damaged, the battery may charge at an abnormal current (or voltage), and an abnormal chemical reaction may occur.

Do not use the battery pack if it is damaged in any way! The battery may generate heat or smoke, rupture, or burst into flame.

Do not solder directly onto the battery!

If the insulator is melted or the gas release vent or safety function is damaged, the battery may generate heat or smoke, rupture, or burst into flame.

Do not reverse the battery polarity (and terminals)! When charging a reversed battery, an abnormal chemical reaction may occur. In some cases, an unexpected large amount of current may flow upon discharging. The battery may generate heat or smoke, rupture, or burst into flame.

Image 15
Contents TK-3230 Features Thank YouOperating Conditions Channel Spacing FCC License InformationFCC Warning IiiSafety Information Precautions Page Contents Viii Supplied Accessories Unpacking and Checking EquipmentPart Number Quantity PTT Push to Talk switch Antenna LED Indicator Menu keyPower switch Volume controlDisplay Icon DescriptionPreparation Battery Pack PrecautionsDo not incinerate or apply heat to the battery Information concerning the Li-ion battery packDo not disassemble or reconstruct battery Do not short-circuit the batteryDo not jar or throw the battery Do not touch a ruptured and leaking battery Do not reverse-charge or reverse-connect the batteryUsing the Li-ion Battery Pack Installing/ Removing the Battery Pack Charging the Battery Pack Installing/ Removing the Belt Clip Installing/ Removing Optional Accessories Select a Channel Switch the Power onAdjust the Volume Getting StartedMake a Call Channel frequency setup Press the or key to select your desired value Quiet Talk/ Digital Quiet TalkScanning the Channels Revert Channel Squelch Level Monitoring a ChannelVoice Activated Control VOX VOX OperationVOX Gain Level VOX Delay Time Transmit Inhibit While Receiving VOX Proceed Tone Privacy Talk Call Key Setup Call Alert Tone Call Alert Side Tone Selcall Selective Calling Press the PTT switch to transmit the selected selcall IDReceiving a Selcall PTT ID Mute Hold Time Caller ID Display Transmit Power Operating featuresKey Lock CompanderDisplay Backlight Super LockMic Sense Time-out Timer Battery Saver Battery Level Indicator Incoming Call Notification Beep Tone Busy Channel Lockout BCLMode Reset Timer Press the Menu key then press or to select a Call ID type ID List SEtting ModeResetting the Transceiver Optional Accessories Menus Name Settings Default Ref. PgOFF/ 5 500 Mute Hold Time 1000/ 15 Display QT Freq QT tones/ DQT codesDisplay DQT Code Display DQT Code Display DQT Code Setup Channel FrequenciesNumber MHz Specifications Problem Solution Troubleshooting Guide