Kenwood TK-3230 instruction manual Installing/ Removing Optional Accessories

Page 21

Installing/ Removing Optional Accessories

Note: Always switch OFF the transceiver power when installing or removing optional accessories.

The following accessories can be used with this transceiver:

KMC-17 Speaker-Microphone

KMC-21 Speaker-Microphone

KHS-22 Headset

EMC-3 Clip Microphone with Earphone

KBH-14 Belt clip

To install these accessories:

1Open the SP/MIC tabs on the side of the transceiver.

2 Insert the accessory’s plugs into the SP/MIC jacks.

3 When you remove the accessory from the transceiver, be sure to cover the SP/MIC jacks with the attached tabs, in order to keep dust and dirt away from the contacts.

Note: Refer to the accessory instruction manuals for detailed instructions on each of these accessories.

12

Image 21
Contents TK-3230 Features Thank YouOperating Conditions Channel Spacing FCC License InformationFCC Warning IiiSafety Information Precautions Page Contents Viii Supplied Accessories Unpacking and Checking EquipmentPart Number Quantity Power switch Antenna LED Indicator Menu keyVolume control PTT Push to Talk switchDisplay Icon DescriptionPreparation Battery Pack PrecautionsDo not disassemble or reconstruct battery Information concerning the Li-ion battery packDo not short-circuit the battery Do not incinerate or apply heat to the batteryDo not jar or throw the battery Do not touch a ruptured and leaking battery Do not reverse-charge or reverse-connect the batteryUsing the Li-ion Battery Pack Installing/ Removing the Battery Pack Charging the Battery Pack Installing/ Removing the Belt Clip Installing/ Removing Optional Accessories Adjust the Volume Switch the Power onGetting Started Select a ChannelMake a Call Channel frequency setup Press the or key to select your desired value Quiet Talk/ Digital Quiet TalkScanning the Channels Revert Channel Squelch Level Monitoring a ChannelVoice Activated Control VOX VOX OperationVOX Gain Level VOX Delay Time Transmit Inhibit While Receiving VOX Proceed Tone Privacy Talk Call Key Setup Call Alert Tone Call Alert Side Tone Selcall Selective Calling Press the PTT switch to transmit the selected selcall IDReceiving a Selcall PTT ID Mute Hold Time Caller ID Display Transmit Power Operating featuresKey Lock CompanderDisplay Backlight Super LockMic Sense Time-out Timer Battery Saver Battery Level Indicator Incoming Call Notification Beep Tone Busy Channel Lockout BCLMode Reset Timer Press the Menu key then press or to select a Call ID type ID List SEtting ModeResetting the Transceiver Optional Accessories Menus Name Settings Default Ref. PgOFF/ 5 500 Mute Hold Time 1000/ 15 Display QT Freq QT tones/ DQT codesDisplay DQT Code Display DQT Code Display DQT Code Setup Channel FrequenciesNumber MHz Specifications Problem Solution Troubleshooting Guide