Kenwood TK-3230 instruction manual Iii, FCC Warning

Page 4

Notices to the User

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

One or more of the following statements may be applicable:

FCC WARNING

This equipment generates or uses radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCC

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can generate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur

in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer for technical assistance.

iii

Image 4
Contents TK-3230 Thank You FeaturesOperating Conditions FCC License Information Channel SpacingIii FCC WarningSafety Information Precautions Page Contents Viii Unpacking and Checking Equipment Supplied AccessoriesPart Number Quantity Antenna LED Indicator Menu key Power switchVolume control PTT Push to Talk switchIcon Description DisplayBattery Pack Precautions PreparationInformation concerning the Li-ion battery pack Do not disassemble or reconstruct batteryDo not short-circuit the battery Do not incinerate or apply heat to the batteryDo not jar or throw the battery Do not reverse-charge or reverse-connect the battery Do not touch a ruptured and leaking batteryUsing the Li-ion Battery Pack Installing/ Removing the Battery Pack Charging the Battery Pack Installing/ Removing the Belt Clip Installing/ Removing Optional Accessories Switch the Power on Adjust the VolumeGetting Started Select a ChannelMake a Call Channel frequency setup Quiet Talk/ Digital Quiet Talk Press the or key to select your desired valueScanning the Channels Revert Channel Monitoring a Channel Squelch LevelVOX Operation Voice Activated Control VOXVOX Gain Level VOX Delay Time Transmit Inhibit While Receiving VOX Proceed Tone Privacy Talk Call Key Setup Call Alert Tone Call Alert Side Tone Press the PTT switch to transmit the selected selcall ID Selcall Selective CallingReceiving a Selcall PTT ID Mute Hold Time Caller ID Display Operating features Transmit PowerCompander Key LockSuper Lock Display BacklightMic Sense Time-out Timer Battery Saver Battery Level Indicator Incoming Call Notification Busy Channel Lockout BCL Beep ToneMode Reset Timer ID List SEtting Mode Press the Menu key then press or to select a Call ID typeResetting the Transceiver Optional Accessories Name Settings Default Ref. Pg MenusOFF/ 5 500 Mute Hold Time 1000/ 15 QT tones/ DQT codes Display QT FreqDisplay DQT Code Display DQT Code Display DQT Code Channel Frequencies SetupNumber MHz Specifications Troubleshooting Guide Problem Solution