Kenwood TK-3230 instruction manual Precautions

Page 6

•Government law prohibits the operation of unlicensed radio transmitters within the territories under government control.

•Illegal operation is punishable by fine and/or imprisonment.

•Refer service to qualified technicians only.

Safety: It is important that the operator is aware of and understands hazards common to the operation of any transceiver.

Precautions

•Do not charge the transceiver and battery pack when they are wet.

•Ensure that there are no metallic items located between the transceiver and the battery pack.

•Do not use options not specified by Kenwood.

•If the die-cast chassis or other transceiver part is damaged, do not touch the damaged part.

•If a headset or headphone is connected to the transceiver, reduce the transceiver volume. Pay attention to the volume level when turning the squelch off.

•Do not place the microphone cable around your neck while near machinery that may catch the cable.

•Do not place the transceiver on unstable surfaces.

•Ensure that the end of the antenna does not touch your eyes.

•When the transceiver is used for transmission for many hours, the radiator and chassis will become hot. Do not touch these locations when replacing the battery pack.

•Do not immerse the transceiver in water.

•Always switch the transceiver power off when installing optional accessories.

Image 6

Contents TK-3230 Features Thank YouOperating Conditions FCC License Information Channel SpacingIii FCC WarningSafety Information Precautions Page Contents Viii Supplied Accessories Unpacking and Checking EquipmentPart Number Quantity Volume control Antenna LED Indicator Menu keyPower switch PTT Push to Talk switchIcon Description DisplayBattery Pack Precautions PreparationDo not short-circuit the battery Information concerning the Li-ion battery packDo not disassemble or reconstruct battery Do not incinerate or apply heat to the batteryDo not jar or throw the battery Do not reverse-charge or reverse-connect the battery Do not touch a ruptured and leaking batteryUsing the Li-ion Battery Pack Installing/ Removing the Battery Pack Charging the Battery Pack Installing/ Removing the Belt Clip Installing/ Removing Optional Accessories Getting Started Switch the Power onAdjust the Volume Select a ChannelMake a Call Channel frequency setup Quiet Talk/ Digital Quiet Talk Press the or key to select your desired valueScanning the Channels Revert Channel Monitoring a Channel Squelch LevelVoice Activated Control VOX VOX OperationVOX Gain Level VOX Delay Time Transmit Inhibit While Receiving VOX Proceed Tone Privacy Talk Call Key Setup Call Alert Tone Call Alert Side Tone Press the PTT switch to transmit the selected selcall ID Selcall Selective CallingReceiving a Selcall PTT ID Mute Hold Time Caller ID Display Operating features Transmit PowerCompander Key LockSuper Lock Display BacklightMic Sense Time-out Timer Battery Saver Battery Level Indicator Incoming Call Notification Busy Channel Lockout BCL Beep ToneMode Reset Timer ID List SEtting Mode Press the Menu key then press or to select a Call ID typeResetting the Transceiver Optional Accessories Name Settings Default Ref. Pg MenusOFF/ 5 500 Mute Hold Time 1000/ 15 QT tones/ DQT codes Display QT FreqDisplay DQT Code Display DQT Code Display DQT Code Setup Channel FrequenciesNumber MHz Specifications Troubleshooting Guide Problem Solution