Kenwood TK-3230 instruction manual Resetting the Transceiver

Page 53

Resetting the Transceiver

At some point in time, you may desire to reset the transceiver settings to their default values. (Default values are listed on pages 46 ~ 47.)

To reset the transceiver:

1With the transceiver power OFF, press and hold the , , and MON keys while turning the transceiver power ON.

•“ ” (reset) will appear on the display.

2Release the , , and MON keys.

•The confirmation message “ ” (sure) will appear on the display.

3Press the PTT switch to reset the transceiver.

•Press any other key to cancel the reset.

Note: Reset will function even if Super Lock has been activated.

44

Image 53

Contents TK-3230 Operating Conditions FeaturesThank You Channel Spacing FCC License InformationFCC Warning IiiSafety Information Precautions Page Contents Viii Part Number Quantity Supplied AccessoriesUnpacking and Checking Equipment Power switch Antenna LED Indicator Menu keyVolume control PTT Push to Talk switchDisplay Icon DescriptionPreparation Battery Pack PrecautionsDo not disassemble or reconstruct battery Information concerning the Li-ion battery packDo not short-circuit the battery Do not incinerate or apply heat to the batteryDo not jar or throw the battery Do not touch a ruptured and leaking battery Do not reverse-charge or reverse-connect the batteryUsing the Li-ion Battery Pack Installing/ Removing the Battery Pack Charging the Battery Pack Installing/ Removing the Belt Clip Installing/ Removing Optional Accessories Adjust the Volume Switch the Power onGetting Started Select a ChannelMake a Call Channel frequency setup Press the or key to select your desired value Quiet Talk/ Digital Quiet TalkScanning the Channels Revert Channel Squelch Level Monitoring a ChannelVOX Gain Level Voice Activated Control VOXVOX Operation VOX Delay Time Transmit Inhibit While Receiving VOX Proceed Tone Privacy Talk Call Key Setup Call Alert Tone Call Alert Side Tone Selcall Selective Calling Press the PTT switch to transmit the selected selcall IDReceiving a Selcall PTT ID Mute Hold Time Caller ID Display Transmit Power Operating featuresKey Lock CompanderDisplay Backlight Super LockMic Sense Time-out Timer Battery Saver Battery Level Indicator Incoming Call Notification Beep Tone Busy Channel Lockout BCLMode Reset Timer Press the Menu key then press or to select a Call ID type ID List SEtting ModeResetting the Transceiver Optional Accessories Menus Name Settings Default Ref. PgOFF/ 5 500 Mute Hold Time 1000/ 15 Display QT Freq QT tones/ DQT codesDisplay DQT Code Display DQT Code Display DQT Code Number MHz SetupChannel Frequencies Specifications Problem Solution Troubleshooting Guide