Kenwood TK-3230 instruction manual Installing/ Removing the Belt Clip

Page 20

3Slide a battery pack or a transceiver equipped with a battery pack into the battery pack slot.

•Make sure the metal contacts of the battery pack mate securely with the charger terminals.

•The indicator lights red and charging starts.

4When charging is completed, the indicator lights green. Remove the battery pack or the transceiver from the battery pack slot.

•It takes approximately 2.5 hours to charge the battery pack.

•When the charger will not be used for a long time, unplug the AC adapter from the AC outlet.

Installing/ Removing the Belt Clip

If desired, attach the belt clip to the rear of the transceiver using the 2 supplied screws.

Charger terminals

Indicator

11

Image 20

Contents TK-3230 Operating Conditions FeaturesThank You FCC License Information Channel SpacingIii FCC WarningSafety Information Precautions Page Contents Viii Part Number Quantity Supplied AccessoriesUnpacking and Checking Equipment Antenna LED Indicator Menu key Power switchVolume control PTT Push to Talk switchIcon Description DisplayBattery Pack Precautions PreparationInformation concerning the Li-ion battery pack Do not disassemble or reconstruct batteryDo not short-circuit the battery Do not incinerate or apply heat to the batteryDo not jar or throw the battery Do not reverse-charge or reverse-connect the battery Do not touch a ruptured and leaking batteryUsing the Li-ion Battery Pack Installing/ Removing the Battery Pack Charging the Battery Pack Installing/ Removing the Belt Clip Installing/ Removing Optional Accessories Switch the Power on Adjust the VolumeGetting Started Select a ChannelMake a Call Channel frequency setup Quiet Talk/ Digital Quiet Talk Press the or key to select your desired valueScanning the Channels Revert Channel Monitoring a Channel Squelch LevelVOX Gain Level Voice Activated Control VOXVOX Operation VOX Delay Time Transmit Inhibit While Receiving VOX Proceed Tone Privacy Talk Call Key Setup Call Alert Tone Call Alert Side Tone Press the PTT switch to transmit the selected selcall ID Selcall Selective CallingReceiving a Selcall PTT ID Mute Hold Time Caller ID Display Operating features Transmit PowerCompander Key LockSuper Lock Display BacklightMic Sense Time-out Timer Battery Saver Battery Level Indicator Incoming Call Notification Busy Channel Lockout BCL Beep ToneMode Reset Timer ID List SEtting Mode Press the Menu key then press or to select a Call ID typeResetting the Transceiver Optional Accessories Name Settings Default Ref. Pg MenusOFF/ 5 500 Mute Hold Time 1000/ 15 QT tones/ DQT codes Display QT FreqDisplay DQT Code Display DQT Code Display DQT Code Number MHz SetupChannel Frequencies Specifications Troubleshooting Guide Problem Solution