To begin scanning:
1Press and hold the 
key for 1 second.
•“ 
” appears on the display.
2When a signal is detected and the QT/ DQT matches, the channel number appears on the display and blinks.
3When the signal is no longer present, the transceiver waits for 5 seconds before scanning continues.
•If a new signal appears before the 5 seconds elapse, the transceiver will remain on the channel until the new signal is no longer present, at which time it will again wait for 5 seconds before continuing.
4To end the scan at any time, press and hold the 
key for 1 second.
•The transceiver returns to the channel you were using before you started scanning.
Revert Channel
The revert channel is the channel from which you start scanning. So, for example, if you are on channel 1 when you begin to scan, your revert channel is channel 1.
During scan, pressing the PTT switch will automatically select the transceiver’s revert channel (in the above example, channel 1) and you will begin transmitting. However, if you are currently paused on another channel after having received a signal (for example, channel 2), pressing the PTT switch will allow you to transmit on that channel, rather than returning
to the revert channel. Scanning will resume after 5 seconds, unless a signal is present on the channel.
18