Cobra Electronics LI 6500WXC owner manual Set Ctcss Privacy Codes, To select a Ctcss privacy code

Page 13

Introduction

Operation

Customer Assistance Warranty

Set CTCSS Privacy Codes

•

Mode Button

CTCSS Privacy Code

Channel Buttons

To select a CTCSS privacy code:

1.After selecting a channel, press the

Mode button until the CTCSS icon appears and the small numbers flash on the display (01 through 38).

NOTE

If DCS is turned on at the channel selected, the display will flash the CTCSS icon and “OFF.” To switch from DCS to CTCSS, press the Channel Up or Channel Down button while the display is flashing “OFF.” The display will then show the small numbers flashing and you will then be able

to proceed to step 2.

2.Press using the Channel Up or Channel Down button to select a CTCSS privacy code. You can hold the Channel Up or Channel Down button for fast advance.

3.When your desired CTCSS privacy code is displayed, choose one of the following:

a.Press the Mode button to enter the new setting and proceed to other functions.

b.Press the Lock/Enter button to enter the new setting and return to Standby mode.

c.Do not press any buttons for 15 seconds to enter the new setting and return to Standby mode.

9

Image 13

Contents LI 6500WXC Making Life Easier and Safer Product Features Privacy Codes FeaturesCaring for Your microTALK Radio Replace battery compartment cover and belt clipEstimated operation time on full charge 12 hours Insert radios into desktop charger as shown Using Your RadioOperation Or Channel Down button ChannelsListening for a Response Call ButtonTo Illuminate Display Press and release the HiLow buttonSeconds To turn the lock feature on or off Lock FeatureAuto Squelch/Maximum Range For less than five secondsTo attach a speaker/microphone Signal Strength MeterTo connect a wall charger/adapter MicroTALK RangeScrolling through Mode Functions Mode FunctionsSet Keystroke Tones On/Off Privacy CodesTo select a Ctcss privacy code Set Ctcss Privacy CodesAfter selecting a channel, press To proceed to stepTo select a DCS privacy code Set DCS Privacy CodesSmall numbers flash on the display ThroughTo listen to All Hazards Radio channels NOAA* All Hazards Radio ChannelsVoice Activated Transmit VOX To turn VOX mode on or offTo set VOX sensitivity To program a memory location Memory LocationsPress the Lock/Enter button to enter Press the Lock/Enter buttonChoose one of the following Press the Mode button toDisplay To recall a stored memory channel locationWhile recalling a stored memory location Flash on the display To de-program a memory locationWhile de-programming a memory location Your microTALK radio can automatically scan channels Channel ScanTo scan channels If you press the Talk button while scanning, but more than Press the Mode button to proceed to set privacyTo scan privacy codes Privacy Code ScanMode Functions To scan memory locations Memory Location ScanPress the Mode button to proceed to other functions VibrAlert and Call Alert To change call settingsIs displayed To change a call tone setting Call Tone SettingsPress the Mode button until Roger Beep Confirmation ToneTo change keystroke tones Keystroke TonesGeneral Specifications General Specifications and FCC LicenseImportant Notice FCC License Required Product Service Product ServiceSafety Information for microTALK Radios Safety and Trademark AcknowledgementLimited One-Year Warranty on Radios & Charger Warranty