Cobra Electronics LI 6500WXC owner manual Safety and Trademark Acknowledgement

Page 33

Safety and Trademark

Acknowledgement

Customer Assistance

Safety Information for microTALK® Radios

•

Your wireless handheld portable transceiver contains a low power transmitter. When the talk button is pushed, it sends out radio frequency (RF) signals. The device is authorized to operate at a duty factor not to exceed 50%. In August 1996, the Federal Communications Commission (FCC) adopted RF exposure guidelines with safety levels for handheld wireless devices.

Important:

FCC RF Exposure Requirements: For body-worn operation, this radio has been tested and meets the FCC RF exposure guidelines when used with Cobra accessories supplied or designated for this product. Use of other accessories may not ensure compliance with FCC RF exposure guidelines. Use only the supplied antenna. Unauthorized antennas, modifications, or attachments could damage the transmitter and may violate FCC regulations.

Normal Position:

Hold the transmitter approximately five cm (two inches) from your face and speak in a normal voice, with the antenna pointed up and away.

Trademark Acknowledgement

•

Cobra®, microTALK®, Nothing Comes Close to a Cobra®, VibrAlert® and the snake design are registered trademarks of Cobra Electronics Corporation, USA. Cobra Electronics Corporation™ is a trademark

of Cobra Electronics Corporation, USA.

The Cobra line of quality products includes

•

CB Radios • microTALK® Radios • Radar/Laser Detectors • Safety Alert® Traffic Warning Systems • Handheld GPS Receivers • Mobile GPS Navigation Systems • HighGear® Accessories • CobraMarine® VHF Radios • Marine Chartplotters •

Power Inverters • Accessories

29

Image 33

Contents LI 6500WXC Making Life Easier and Safer Product Features Privacy Codes FeaturesReplace battery compartment cover and belt clip Caring for Your microTALK RadioEstimated operation time on full charge 12 hours Insert radios into desktop charger as shown Using Your RadioOperation Or Channel Down button ChannelsListening for a Response Call ButtonPress and release the HiLow button To Illuminate DisplaySeconds To turn the lock feature on or off Lock FeatureAuto Squelch/Maximum Range For less than five secondsTo attach a speaker/microphone Signal Strength MeterTo connect a wall charger/adapter MicroTALK RangeScrolling through Mode Functions Mode FunctionsSet Keystroke Tones On/Off Privacy CodesTo select a Ctcss privacy code Set Ctcss Privacy CodesAfter selecting a channel, press To proceed to stepTo select a DCS privacy code Set DCS Privacy CodesSmall numbers flash on the display ThroughTo listen to All Hazards Radio channels NOAA* All Hazards Radio ChannelsTo turn VOX mode on or off Voice Activated Transmit VOXTo set VOX sensitivity To program a memory location Memory LocationsPress the Lock/Enter button to enter Press the Lock/Enter buttonChoose one of the following Press the Mode button toTo recall a stored memory channel location DisplayWhile recalling a stored memory location To de-program a memory location Flash on the displayWhile de-programming a memory location Channel Scan Your microTALK radio can automatically scan channelsTo scan channels If you press the Talk button while scanning, but more than Press the Mode button to proceed to set privacyTo scan privacy codes Privacy Code ScanMode Functions To scan memory locations Memory Location ScanPress the Mode button to proceed to other functions To change call settings VibrAlert and Call AlertIs displayed To change a call tone setting Call Tone SettingsPress the Mode button until Roger Beep Confirmation ToneTo change keystroke tones Keystroke TonesGeneral Specifications General Specifications and FCC LicenseImportant Notice FCC License Required Product Service Product ServiceSafety Information for microTALK Radios Safety and Trademark AcknowledgementLimited One-Year Warranty on Radios & Charger Warranty