Cobra Electronics LI 6500WXC owner manual To recall a stored memory channel location, Display

Page 19

Introduction

Mode Button

Memory Icon

Channel Buttons


Operation	Customer Assistance	Warranty

To recall a stored memory channel location:

1.Press the Mode button until the Memory icon and the memory location number flash on the

display.

2.Press the Channel Up or Channel Down button to select a memory location

(0 through 9).

If a location has been programmed before, its associated channel/privacy code will be shown on the display.

3. Press the Talk button to return to Standby

mode on the selected memory location.

A memory location can be reprogrammed at any time it is displayed. Press the Lock/Enter button to begin.

While recalling a stored memory location,

if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code displayed before you entered mode functions.

Image 19

Contents LI 6500WXC Making Life Easier and Safer Product Features Privacy Codes FeaturesCaring for Your microTALK Radio Replace battery compartment cover and belt clipEstimated operation time on full charge 12 hours Insert radios into desktop charger as shown Using Your RadioOperation Call Button ChannelsOr Channel Down button Listening for a ResponseTo Illuminate Display Press and release the HiLow buttonSeconds For less than five seconds Lock FeatureTo turn the lock feature on or off Auto Squelch/Maximum RangeMicroTALK Range Signal Strength MeterTo attach a speaker/microphone To connect a wall charger/adapterPrivacy Codes Mode FunctionsScrolling through Mode Functions Set Keystroke Tones On/OffTo proceed to step Set Ctcss Privacy CodesTo select a Ctcss privacy code After selecting a channel, pressThrough Set DCS Privacy CodesTo select a DCS privacy code Small numbers flash on the displayTo listen to All Hazards Radio channels NOAA* All Hazards Radio ChannelsVoice Activated Transmit VOX To turn VOX mode on or offTo set VOX sensitivity Press the Lock/Enter button Memory LocationsTo program a memory location Press the Lock/Enter button to enterChoose one of the following Press the Mode button toDisplay To recall a stored memory channel locationWhile recalling a stored memory location Flash on the display To de-program a memory locationWhile de-programming a memory location Your microTALK radio can automatically scan channels Channel ScanTo scan channels If you press the Talk button while scanning, but more than Press the Mode button to proceed to set privacyTo scan privacy codes Privacy Code ScanMode Functions To scan memory locations Memory Location ScanPress the Mode button to proceed to other functions VibrAlert and Call Alert To change call settingsIs displayed Roger Beep Confirmation Tone Call Tone SettingsTo change a call tone setting Press the Mode button untilTo change keystroke tones Keystroke TonesGeneral Specifications General Specifications and FCC LicenseImportant Notice FCC License Required Product Service Product ServiceSafety Information for microTALK Radios Safety and Trademark AcknowledgementLimited One-Year Warranty on Radios & Charger Warranty