Cobra Electronics LI 6500WXC owner manual Memory Location Scan, To scan memory locations

Page 25


	Introduction	Operation	Customer Assistance	Warranty

Memory Location Scan

•

Your microTALK radio can automatically scan up to 10 programmed Memory Locations.

If there are one or fewer memory locations programmed in your radio, the scan memory locations option will not be available. To program at least two memory locations, see program memory locations on page 13.

Mode Button

Scanning Locations

Channel Buttons

To scan memory locations:

1.Press the Mode button until the Scan icon, Memory icon and the memory location number flash on the display.

2.Press the Channel Up or Channel Down button to begin scanning memory locations.

The Scan icon and the Memory icon will continue to be displayed when memory location scan is on. Your radio will continue to scan memory locations and stop if an incoming transmission is detected. Your radio will remain on that memory location for 10 seconds.

While setting memory location scan, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code displayed before you entered mode functions.

21

Image 25

Contents LI 6500WXC Making Life Easier and Safer Product Features Privacy Codes FeaturesCaring for Your microTALK Radio Replace battery compartment cover and belt clipEstimated operation time on full charge 12 hours Insert radios into desktop charger as shown Using Your RadioOperation Or Channel Down button ChannelsListening for a Response Call ButtonTo Illuminate Display Press and release the HiLow buttonSeconds To turn the lock feature on or off Lock FeatureAuto Squelch/Maximum Range For less than five secondsTo attach a speaker/microphone Signal Strength MeterTo connect a wall charger/adapter MicroTALK RangeScrolling through Mode Functions Mode FunctionsSet Keystroke Tones On/Off Privacy CodesTo select a Ctcss privacy code Set Ctcss Privacy CodesAfter selecting a channel, press To proceed to stepTo select a DCS privacy code Set DCS Privacy CodesSmall numbers flash on the display ThroughTo listen to All Hazards Radio channels NOAA* All Hazards Radio ChannelsVoice Activated Transmit VOX To turn VOX mode on or offTo set VOX sensitivity To program a memory location Memory LocationsPress the Lock/Enter button to enter Press the Lock/Enter buttonChoose one of the following Press the Mode button toDisplay To recall a stored memory channel locationWhile recalling a stored memory location Flash on the display To de-program a memory locationWhile de-programming a memory location Your microTALK radio can automatically scan channels Channel ScanTo scan channels If you press the Talk button while scanning, but more than Press the Mode button to proceed to set privacyTo scan privacy codes Privacy Code ScanMode Functions To scan memory locations Memory Location ScanPress the Mode button to proceed to other functions VibrAlert and Call Alert To change call settingsIs displayed To change a call tone setting Call Tone SettingsPress the Mode button until Roger Beep Confirmation ToneTo change keystroke tones Keystroke TonesGeneral Specifications General Specifications and FCC LicenseImportant Notice FCC License Required Product Service Product ServiceSafety Information for microTALK Radios Safety and Trademark AcknowledgementLimited One-Year Warranty on Radios & Charger Warranty