Cobra Electronics LI 6500WXC VibrAlert and Call Alert, To change call settings, Is displayed

Page 27

 

 

 

 

 

 

 

Introduction

Operation

Customer Assistance

Warranty

 

VibrAlert and Call Alert

Your microTALK radio can alert you to incoming signals by sounding an audible call tone, by vibrating silently or both.

Mode Button

Channel Buttons

To change call settings:

1.Press the Mode button until the Call Setting icon flashes on the display. The current setting (“01” vibrate + ring, “02” vibrate only or “03” ring only)

is displayed.

2.Press the Channel Up or Channel Down button to change the call setting.

3.Choose one of the following:

VibrAlert + Ring

VibrAlert Only

Ring Only

a. Press the Mode button to enter the new setting and proceed to other functions.

b. Press the Lock/Enter button to enter the new setting and return to Standby mode.

23

Image 27
Contents LI 6500WXC Making Life Easier and Safer Product Features Privacy Codes FeaturesReplace battery compartment cover and belt clip Caring for Your microTALK RadioEstimated operation time on full charge 12 hours Insert radios into desktop charger as shown Using Your RadioOperation Call Button ChannelsOr Channel Down button Listening for a ResponsePress and release the HiLow button To Illuminate DisplaySeconds For less than five seconds Lock FeatureTo turn the lock feature on or off Auto Squelch/Maximum RangeMicroTALK Range Signal Strength MeterTo attach a speaker/microphone To connect a wall charger/adapterPrivacy Codes Mode FunctionsScrolling through Mode Functions Set Keystroke Tones On/OffTo proceed to step Set Ctcss Privacy CodesTo select a Ctcss privacy code After selecting a channel, pressThrough Set DCS Privacy CodesTo select a DCS privacy code Small numbers flash on the displayTo listen to All Hazards Radio channels NOAA* All Hazards Radio ChannelsTo turn VOX mode on or off Voice Activated Transmit VOXTo set VOX sensitivity Press the Lock/Enter button Memory LocationsTo program a memory location Press the Lock/Enter button to enterChoose one of the following Press the Mode button toTo recall a stored memory channel location DisplayWhile recalling a stored memory location To de-program a memory location Flash on the displayWhile de-programming a memory location Channel Scan Your microTALK radio can automatically scan channelsTo scan channels If you press the Talk button while scanning, but more than Press the Mode button to proceed to set privacyTo scan privacy codes Privacy Code ScanMode Functions To scan memory locations Memory Location ScanPress the Mode button to proceed to other functions To change call settings VibrAlert and Call AlertIs displayed Roger Beep Confirmation Tone Call Tone SettingsTo change a call tone setting Press the Mode button untilTo change keystroke tones Keystroke TonesGeneral Specifications General Specifications and FCC LicenseImportant Notice FCC License Required Product Service Product ServiceSafety Information for microTALK Radios Safety and Trademark AcknowledgementLimited One-Year Warranty on Radios & Charger Warranty