Vertex Standard FT-1000MP Vfo-A Vfo-B, Status Flag Byte #1 Contents, Status Flag Byte #4 Contents

CAT System Computer Control

STATUS UPDATE DATA ORGANIZATION

		1863-Byte Status Updata Data (sent L-to-R)
Status	Memory	Operating	VFO-A	VFO-B	Memory
Flags	Channel No.	Data	Data	Data	Data
6 byte	1 byte	16 byte	16 byte	16 byte	16 bytes (x 113 memories = 1808 bytes total)
(A)	(B)	(C)	(D)	(E)	(F)

6-Byte Status Flags Record Table

Bit	STATUS FLAG BYTE #1 CONTENTS
Offset

0Split Frequency Operation

1Dual Receive Operation

2Antenna Tuning In Progress

3CAT System Activated

4SUB VFO-B In-Use (Rx/Tx LED on)

5Keypad Entry In Progress

6Main Receiver Muted

7PTT Keyed (Tx Active)

Bit	STATUS FLAG BYTE #4 CONTENTS
Offset

02nd IF 455 kHz Filter Selection Active

11st IF 8.2 MHz Filter Selection Active

2N/A

3N/A

4PTT Keyed via CAT Command

5General Coverage TX Inhibit

6Key Release Timer Active

7Tx Inhibit

Bit	STATUS FLAG BYTE #2 CONTENTS
Offset

05-sec. MEM CHK Timer Active

1Memory Checking In Progress

2Dual VFO Tracking Active

3Quick Memory Bank Selected

4Memory Tuning Active

5VFO Operation

6Memory Operation

7General Coverage Reception

Bit	STATUS FLAG BYTE #5 CONTENTS
Offset

0RTTY TX Idle

1N/A

2N/A

3Grouped Memory MOde Active

4ANT B Selected

5RX ANT Selected

6PMS Tuning Active

7AM Synchronous Mode Active

Bit	STATUS FLAG BYTE #3 CONTENTS
Offset

0FAST Tuning Active

1Antenna Tuner (ATU) In-Line

2SUB VFO-B Locked

3MAIN VFO-A Locked

4Squelch Closed

5Scan Direction (Up/Down)

6Scan Paused

7Auto Memory Write Scanning Active

Bit	STATUS FLAG BYTE #6 CONTENTS
Offset

0Sub Receiver Audio Muted

1Main Receiver Audio Muted

2Dual VFO Tracking

3N/A

4N/A

5VFO Channel Stepping

6Tuner Wait (while tuning)

7AM Synchronous Mode Active

MARK-V FT-1000MP Operating Manual page 89