Programming
Viewing/editing/erasing call block numbers
1MMENUN (right soft key) #217
2MbN: “Block a single number” or “Block range of numbers” a
MSELECTN
3MbN: Select the desired entry. R To exit, press MOFFN.
4To edit a number:
MEDITN a Edit the number. a MSAVEN a MOFFN
To erase a number:
MERASEN a MbN: “Yes” a MSELECTN a MOFFN
Note:
RWhen editing, press the desired dial key to add, MCLEARN to erase.
Erasing all call block numbers
1MMENUN (right soft key) #217
2MbN: “Block a single number” or “Block range of numbers” a
MSELECTN
3MMENUN a MbN: “Erase all” a
MSELECTN
4MbN: “Yes” a MSELECTN
5MbN: “Yes” a MSELECTN a MOFFN
Other programming
Changing the handset name
The default handset name is “Handset 1” to “Handset 6”. You can customize the name of each handset (“Bob”, “Kitchen”, etc.). This is useful when you make intercom calls between handsets. To display the handset name in standby mode, turn on the handset name display feature (page 42).
1MMENUN (right soft key) #104
2Enter the desired name (10 characters max.).
3MSAVEN a MOFFN
Displaying the handset name
You can select whether or not the handset name is displayed in standby mode. The default setting is “Off”.
1MMENUN (right soft key) #105
2MbN: Select the desired setting. a MSAVEN a MOFFN
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base unit.
Important:
RSee page 4 for information on the available model.
Registering a handset to the base unit
The supplied handset and base unit are
1Handset:
MMENUN (right soft key) #130
2Base unit:
Press and hold M
N for about 5 seconds. R If all registered handsets start ringing, press M
N again to stop, then repeat
this step.
3Handset:
Press MOKN, then wait until a long beep sounds.
Deregistering a handset
A handset can cancel its own registration to the base unit, or other handsets registered to
42For assistance, please visit http://www.panasonic.com/help