Using the CD Player, To Change the FM Reception Mode

Presetting Stations

You can preset up to 15 FM stations and up to 15 AM stations into memory using the Remote Control.

Auto Presetting (Using the Unit) —

In each band, you can automatically preset FM-15,AM-15 stations. Preset numbers will be allocated as stations are found, starting from the station currently tuned to and moving up the frequency.

■1. Select a band (AM or FM) by pressing the

TUNER BAND button.

■2. Press the PRESET button for more than two seconds.

■3. Repeat steps 1-2 for the other band.

■ If you want to change any of the auto preset stations, follow the procedure for Manual Presetting.

CAUTION: If the Unit is unplugged or if a power failure occurs, the preset stations will be erased after approx. five minutes. If this happens, you will need to preset the stations again.

Example:Press the PRESET button until the preset number 12 “P- 12” appears.

■Preset Tuning using the Remote Control (Possible only after presetting stations)

Select the station by entering its preset number on the number keys.

•Example:For channel 5, press 5. For channel 15, press +10 then 5.

•The band and the frequency are displayed.

■3. Turn the antenna for best reception.

•For FM broadcast, extend and turn the telescopic antenna.

•For AM broadcast, turn the Unit itself.

For FM		For AM

	Manual Presetting (Using the Re-	English
	mote Control) ————————————	English
	mote Control) ————————————
	Number key(s) (hold for 2 seconds)
	■
	1. Select a band by pressing the TUNER
	BAND button.

■2. Press the 4 or ¢ button to tune in a station.

■3. Set the preset number by pressing and hold- ing the number key on the Remote Control.

•To preset numbers 1 to 10: Press the number key and hold down for 2 seconds.

•To preset numbers 11 to 15: Press and release the +10 but-

ton, then press the second number key (1 to 5) and hold down for 2 seconds.

When the preset display blinks, the setting is stored and you can release the number key. The display returns to the normal band and frequency display.

Example: Preset number = 12

■4. Repeat steps 1 - 3 for each station.

To change the preset stations, repeat the same steps as above.

To Change the FM

Reception Mode

The “STEREO” indicator lights up and you can hear stereo effects, when a program is broadcast in stereo.

However if an FM stereo broadcast is hard to receive or noisy, you can select Monaural mode. Reception improves, but you lose any stereo effect.

Press the TUNER BAND button to select FM MONO mode.

The “MONO” indicator lights up on the display.

To restore the stereo effect, press the TUNER BAND button to select FM Auto mode. The “MONO” indicator goes out.