JVC RC-BZ5RD Using the Tuner, Adjusting the Volume, Sound Effects Sound, Tuning In a Station

English

When power is supplied from the batteries:

When the Unit is turned off with the POWER button on the Unit (the POWER button on the Remote Control is ineffective), the Standby indicator goes out and the display is blank.

To switch off the Unit completely, remove the batteries from the Unit.

Adjusting the Volume

Turn the VOLUME control on the Unit to the right or left to in- crease or decrease the volume level.

CAUTION: DO NOT turn on the Unit and/or start playing any source without first setting the VOL- UME control to 0, as a sudden blast of sound can damage your hearing, speakers and/or head- phones.

For private listening

Connect a pair of headphones to the PHONES jack. No sound comes out of the speakers.

Be sure to turn down the volume before connecting or putting on headphones.

Sound Effects (SOUND)

The System has the following preset sound effects that give you control over the way your music sounds, so you can tailor it to the acoustics of your room and the quality of your source. Test the sound effects out to hear how each affects the music. Note that the effects work only during playback.

Sound effects

FLAT:	No sound effect.
BEAT:	Boosts low and high frequencies.
POP:	Good for vocal music.
CLEAR:	For a wide, dynamic stereo sound.

To get an effect, press the SOUND button repeatedly until the Sound mode you want appears on the display.

Each time you press the SOUND button, the display changes as shown below:

BASS BASS

BEAT POP CLEAR FLAT

To cancel the effect, press the SOUND button until “FLAT” ap- pears on the display

■Using the Tuner

Number keys

TUNER BAND

¢ 4

PRESET

4

¢

TUNER BAND

Band display, Frequency display, Preset channel

REMOTE CONTROL RM-SRCBZ5

You can listen to FM and AM stations. Stations can be tuned in manually, automatically, or from preset memory storage.

One Touch Radio (AC power only)—

Just press the TUNER BAND button to turn on the Unit and start playing the station you were last tuned to.

■You can also switch from any other sound source to the radio by pressing the TUNER BAND button.

Tuning In a Station

■1. Press the TUNER BAND button.

The Band and Frequency you were last tuned to appear on the display.

Each time you press the button, the band changes as follows:

FM Auto FM MONO AM

■2. Select a station using one of the following methods.

(Display when using the Tuner)

■Manual Tuning

Press the 4 or ¢ button repeatedly to move from frequency to frequency until you find the station you want.

or

OR

■Auto Tuning

If you press and hold the 4 or ¢ button for one second or more, the frequency changes down, or up, automatically until a

station is found.

OR

■Preset Tuning using the Unit (Possible only after pre- setting stations)

Press the PRESET button to select the preset station.

After you have selected the preset number, the band and the fre- quency are displayed.

4