Ericsson LBI-38823D manual Sending a Message

Page 53

2.Use the SELect buttons Ior Jto select the desired Channel. The GRP icon will be surpressed, but the field will still display the current Channel selected. The radio is now ready to receive message.

3.Press the SHIFT/CLR button twice ("double click") to disable squelch and monitor the channel. Adjust the VOLUME buttons to the desired audio level.

4.When a message is received (and the correct Busy Tone signal is

NOTE

Pressing the SHIFT/CLR twice ("double click") to monitor the channel, may affect Busy Tone signalling if programmed for the selected channel.

decoded, if programmed and enabled) the receiver will unsquelch and the message will be heard.

SENDING A MESSAGE

1.Turn the radio on and set the desired System and Channel as described in the previous section.

2.Ensure no one is transmitting on the selected channel by pressing the SHIFT/CLR button twice ("double click") and/or observing the display for the absence of the "BSY" indicator to ensure that no one is transmitting on the selected Channel.

3.Holding the radio about 3 inches from your mouth, press the PTT bar and speak as you would normally into the microphone.

4.Release the PTT bar when the transmission is complete and listen for any reply.

53

Image 53

Contents Ericssonz Page Table of Contents Keypad Lock System Model Only Dynamic Regrouping OptionalEmergency Operation Optional Introduction Dual Format PCS Radio Scan Model Dual Format PCS Radio System Model Description SwitchControls ON/OFF PTT ButtonScan Model Keypad SPC HOME/ESCAN-A/D STOLock IndicatorsAvailable on System Model radios only RCLBSY System And Group/Channel IndicatorsStatus Indicators SCN Radio is in the Program modeTurn on Low Battery Standard Tones Power-UpCarrier Control Timer Alert TonesCall Queued Edacs Only Call ReceivedAutokey Edacs Only System BusyIntrinsically Safe Usage Error MessagesOut Of Range/System Inoperative Pictured on Options and AccessoriesOption # Description Options And Accessories Installing the Battery Pack Battery PacksBattery Packs FM Approved Charging the Battery Packs Removing the Battery PackInstalling the Battery Pack Swivel Mount Removal and Replacement Rechargeable Battery Pack DisposalSwivel Mount Removal And Replacement Operating Tips Operating ProceduresWhen using two-way radios, remember the following rules Page NICKEL-CADMIUM Battery Warranty Current System selected Receiving a MessageSending a Message Using the Volume buttons, adjust the volume as necessarySquelch Adjustment Scan Model Radio Press and hold the SHFT/CLR buttonSending a Special Call Sending a Manually Entered Individual Call System Model RadioPage Sending a Manually Entered Interconnect Call Storing Individual And Interconnect Numbers Enter the desired storage location number Edacs Special Call Flowchart Scan Operation Enable/Disable ScanAdd/Delete Groups Wide Area And Priority System Scanning OptionalDtmf Overdial ProSoundDynamic Regrouping Optional Pressing the PTT bar to send the tones To enable an Emergency transmissionHOME/EMERGENCY KEY Definition Emergency Operation Optional Receiving An Emergency CallKeypad Lock System Model Only HomePage GE-MARC Operation Sending a Message Sending a Special Call Sending a Preprogrammed Special Call In Conference Call Sending a Manually Entered Individual Call Sending a Manually Entered Interconnect Call Page Storing Individual And Interconnect Numbers Page Number will be displayed GE-MARC Special Call Flowchart Receiving a Message Direct ModeWide Area System Scan Sending a Message Add/Delete Channels Sending a Manually Entered Interconnect CallTo delete Channels from the scan list Scan must be disabled to add a channel to the scan listThis page intentionally left blank Conventional Mode Operation Sending a Message After all the digits have been keyed in, release the PTT bar Page Frequency Band OPERATOR’S Name Emergency Group System System Number Name TRK/CNV GRP/CHN GRP/CHN USE Warranty Emergency Numbers