Friedrich SH20, SH15 operation manual Typical Installation Sill Plate

920-024-05 (12-04)

The illustrations below show a standard frame construction installation as well as some suggested ways of adapting the support bracket to thick walls and large stone ledges.

Typical Installation Sill Plate
Figure 1	Figure 2
10 - 24 SCREW
10 - 24 FLAT NUT		3/8" (10 MM)
3/8" (10 MM)		SLOPE DOWN
SLOPE DOWN
	CUT
	HERE
#12A X 2" SHEET METAL SCREW		STONE LEDGE
		OUTSIDE WALL
1" X 2" OR 2" X 4" SPACER BETWEEN WALL	DISCARD	CUT TO FIT DIMENSION "A"
		AND BEND DOWN TO FOR A
AND BRACKET SHOULD BE USED ON ALU-	SHADED AREA
		VERTICAL LEG
MINUM, ASBESTOS OR VINYL SIDING
Figure 3	Figure 4
STONE LEDGE	STONE LEDGE
3/8" (10 MM)		3/8" (10 MM) SLOPE DOWN
SLOPE DOWN
		STRAIGHTEN TAB TO LAY FLAT ALONG
#12A X 2" SHEET METAL SCREW		THE BOTTOM RAIL OF THE SHELL.
		SECURE THE LONGEST SIDE OF
2" X 4" SPACER		THE BRACKET TO THE SHELL.
		ADJUST IN OR OUT TO
		REST ON THE LEDGE

STEP 4 CUT WINGBOARD PANELS: Measure and cut the wingboard panels from the supplied masonite (Item #8) to fit the spaces between the side window channels and the sides of the cabinet (See Figure F).

NOTE: AFTER CUTTING PANELS, MAKE A TRIAL TEST TO SEE IF THEY FIT THE SPACE WITH ABOUT 1/8" CLEARANCE BEFORE GOING TO STEP 5.

Figure F

MEASURE DISTANCE "B" TO THE INSIDE

OF THE CHANNEL ON EACH SIDE

CUT HERE AND DISCARD THE CENTER

WASTE MATERIAL

WINGBOARD

SUBTRACT 1/8" (3 MM) FROM DIMENSION "B" AND MEASURE FROM THE EDGE OF THE WINGBOARD (ITEM

# 8), MARK AND CUT WITH A SAW.

11