Return to Section TOC
Return to Section TOC
TOC
Return to Master TOC
Return to Master TOC
TOC
TROUBLESHOOTING & REPAIR | ||
|
WIRE DRIVE MOTOR AND GEAR BOX
REMOVAL AND REPLACEMENT PROCEDURE (CONTINUED)
FIGURE F.10 – WIRE DRIVE PANEL REMOVAL
CONTROL BOX
WIRE DRIVE PANEL
DRIVE GEAR COVER
REPLACEMENT PROCEDURE
Return to Section
Return to Section TOC
Return to Master
Return to Master TOC
1.Line up the gear box with the four holes on the panel. Replace and tighten the four
.50 screws.
2.Insert the drive motor through the panel and gear box. Line up and tighten the three M6 x 1.00 in. phillips pan head screws.
3.Replace the drive gear and secure in place using the screw and lock washer previously removed.
4.Replace the drive rolls and secure the locking rings.
5.Reconnect the motor and tach leads to har- ness.
6.Reassemble the wire drive panel and the con- trol box using the five
7.Reconnect the gas hose and the buss bar assembly.
8.Replace the control box cover using the four
9.Slide the control box into the case and secure it in reverse order.
10.Reinstall the gun.