Lincoln 500 manual Commander / K867 / K775 / LN-7 Connection Diagram

Vantage 500 CUMMINS

COMMANDER / K867 / K775 / LN-7 CONNECTION DIAGRAM

		WARNING
	Do not operate with panels open.			Keep guards in place.
	Disconnect NEGATIVE (-) BATTERY LEAD			Keep away from moving parts.
	before servicing.			Only qualified personnel should install,use
	Do not touch electrically live parts.			or service this equipment.
		SPARE	}
		41
		82
		81			N.D.	LN-7
						WIRE
		42
						FEEDER
		31			31
		32			32
	14 PIN	2			2
	AMPHENOL	4
					4
ELECTRODE	TO WORK	21			21	K291 OR K404
	K867 UNIVERSAL
		GND			GND	INPUT CABLE
	ADAPTER PLUG
					GREEN
	TO WORK	75			75
		76			76
	ELECTRODE CABLE	77	}		77
	TO WIRE FEED UNIT
CAUTION :						K775 OPTIONAL
			N.E.			REMOTE CONTROL

ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE

AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE

DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN

THE ENGINE WELDER OPERATING MANUAL.

N.A. WELDING CABLE MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE

APPILICATIONS. SEE OPERATING MANUAL.

N.B. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE "SELECTOR" SWITCH TO "WIRE WELDING CV".

PLACE WIRE FEEDER SWITCH TO "WIRE FEEDER WITH CONTROL CABLE POSITION.

N.C. IF OPTIONAL REMOTE OUTPUT CONTROL IS USED,CONTROL IS AUTOMATICALLY SWITCHED TO REMOTE CONTROL.

N.D. INSULATE EACH UNUSED LEAD INDIVIDUALLY.

N.E. SPLICE LEADS AND INSULATE.

7-2000

CONNECTION	F-3
DIAGRAM:

DIAGRAMS

F-3

S23983