Panasonic EY7270 Forward Rotation Switch Operation, Reverse Rotation Switch Operation, LED Light

CAUTION:

To prevent damage, do not operate Forward/Reverse lever until the bit comes to a complete stop.

Forward Rotation Switch Operation

1.Push the lever for forward rotation.

2.Depress the trigger switch slightly to start the tool slowly.

3.The speed increases with the amount of depression of the trigger for efficient tightening of screws. The brake operates and the bit stops immediately when the trigger is released.

4.After use, set the lever to its center position (switch lock).

Reverse Rotation Switch Operation

1.Push the lever for reverse rotation. Check the direction of rotation before use.

2.Depress the trigger switch slightly to start the tool slowly.

3.After use, set the lever to its center position (switch lock).

CAUTION:

To eliminate excessive temperature increase of the tool surface, do not operate the tool continuously (using two or more battery packs consecutively). Tool needs cool-off time before switching to another pack.

LED Light

CAUTION:

The built-in LED light is designed to illuminate a small work area temporarily.

Do not use it as a substitute for a regular flashlight, since it does not provide enough illumination.

Pressing the LED light ON/OFF button will turn the LED light on and off.

If the tool has not been operated for 5 minutes while the LED light is on, the light turns off automatically.

The light illuminates with a very low current, and it does not adversely affect the performance of the tool during use or its battery capacity.

The impact mode display on the operation panel will turn off in the following cases:

•5 minutes have passed with no operation;

•During battery replacement.

If the variable speed control trigger is pressed, the impact mode display will return to the previous setting before the light turned off.

This product has a built-in LED light.

This product is classified as a “Class 1 LED Product” under EN 60825-1.

CLASS 1 LED PRODUCT

Caution: DO NOT STARE INTO BEAM.

How to Use the Belt Hook

WARNING:

•Be sure to attach the belt hook securely to the main unit with the screw firmly fastened. When the belt hook is not firmly attached to the main unit, the hook may depart and the main unit may fall.

This may result in an accident or injury.

•Be sure to attach the belt hook firmly and securely onto a waist belt or other belt. Pay attention so that the unit does not slip off from the belt.

This may result in an accident or injury.

- -

EY7270(EU).indb 7

2006/05/25 13:24:58