Porter-Cable N020206-NOV08-0 Maintenance, Customer Responsibilities, To Check Safety Valve

MAINTENANCE

Customer Responsibilities

			Before	Daily	Every	Every	Every	Every	Yearly
			each	or	8	40	100	160
			use	after	hours	hours	hours	hours
				each
				use
Check Safety Valve			•
Drain Tank				•
Oil Leaks					•
Check Pump Oil					•
Change Pump Oil								•
Unusual Noise and/or					•
Vibration
Air Filter							• (1)
Drive Belt-Condition						•
Motor	Pulley/Flywheel						•
alignment
Air compressor pump									•
intake	and	exhaust
valves
Inspect air		lines and	•
fittings for leaks

Head Bolts - Check the torques of the head bolts after the first five hours of operation.

1- more frequent in dusty or humid conditions

Risk of unsafe operation. Unit cycles automatically when power is on. When performing maintenance, you may be exposed to voltage sources, compressed air, or moving parts. Personal injuries can occur. Before performing any maintenance or repair, disconnect power source from the compressor and bleed off all air pressure.

To ensure efficient operation and longer life of the air compressor outfit, a routine maintenance schedule should be prepared and followed. The following routine maintenance schedule is geared to an outfit in a normal working environment operating on a daily basis. If necessary, the schedule should be modified to suit the conditions under which your compressor is used. The modifications will depend upon the hours of operation and the working environment. Compressor outfits in an extremely dirty and/or hostile environment will require a greater frequency of all maintenance checks.

NOTE: See Operation section for the location of controls.

To Check Safety Valve

Risk of bursting. If the safety valve does not work properly, over-pressurization may occur, causing air tank rupture or an explosion.

Risk from flying objects. Always wear certified safety equip-

ment: ANSI Z87.1 eye protection (CAN/CSA Z94.3) with side shields.

1.Before starting compressor, pull the ring on the safety valve to make sure that the safety valve operates freely. If the valve is stuck or does not operate smoothly, it must be replaced with the same type of valve.

N020206 14 - ENG