Grizzly G0606X, G0605X owner manual Outfeed Table, To install the outfeed table

11.Fasten each support leg to the main exten- sion table with four Phillips head screws and flat washers as shown in Figure 19.

Figure 19. Support leg fastened to main

extension table.

12.Rotate both feet until they touch the ground, and tighten the hex nuts to secure the feet.

13.Fasten the shelf end plate to the legs with four Phillips head screws and flat washers as shown in Figure 20.

Figure 20. Installing shelf end plate on extension

table legs.

14.Place the shelf brackets between the cabinet and support legs, and fasten with four M6-1 x 12 hex bolts, four flat washers and two hex nuts (on the outside) as shown in Figure 21.

Note: The flange on the shelf bracket must point up to ensure proper installation.

15.Place the lower shelf on the brackets. G0605X/G0606X Extreme Series 12" Table Saw

Shelf Bracket

Flange

Figure 21. Shelf brackets installed.
Outfeed Table
Components and Hardware Needed:	Qty
Outfeed Table	1
Lower Shelf	1
Shelf End Plate	1
Support Legs	2
Lower Shelf Brackets	2
Fence Tube	1
Flange Bolts M8-1.25 x 16	2
Hex Bolts M6-1 x 12	4
Phillips Head Screws M6-1 x 12	12
Feet 3⁄8-16 x 2	2
Hex Nuts M6-1	2
Hex Nuts M8-1.25	2
Hex Nuts 3⁄8-16	2
Flat Washers 6mm	16
Flange Bolts M8-1.25 x 12	9
To install the outfeed table:

1.Turn the outfeed table upside down and place it on a level surface.

2.Install the feet, support legs, and shelf end plate in the same manner as described in Extension Table instructions.

-21-