Grizzly G0605X, G0606X owner manual Shim procedure diagram a

8.Tilt the blade to 45° and repeat Steps 2-6. If the blade is still parallel to the miter slot, con- tinue on to the Blade Alignment procedure. Otherwise, continue with the next step.

9.If the blade was parallel to the miter slot at 90° but not at 45°, the table will need to be shimmed with metal shim stock. The shims are placed under the table over each of the three table mounting bolts.

10.Refer to Figures 82 and 83 for shim place- ment. If the distance of A is shorter than B, shim(s) will need to be placed under corners #1 and #2. If the distance of B is shorter than A, shim(s) will need to be placed under cor- ner #3. Very thin shim stock works well.

11.Tighten down one bolt a small amount and then move on to each of the others, tighten- ing each down the same amount. Continue to rotate through the bolts, tightening them a little each time until they are all secure.

12.Now recheck the blade to miter slot at 90° and 45° by repeating Steps 2-6. If the dis- tance of A and B are equal, continue to the Blade Alignment procedure. If the distances are still off, repeat Steps 10-13.

13.Once you feel you have the miter slot adjust- ed to the blade, recheck all measurements and be sure the table mounting bolts are secure. Also, if you ever remove the table in the future, be sure to make note of shim placements and reassemble exactly how it came apart.

-52-

Figure 82. Shim procedure diagram A.

Figure 83. Shim procedure diagram B.

G0605X/G0606X Extreme Series 12" Table Saw