Grizzly G0606X, G0605X Blade Tilt Stops, To set the 90 stop bolt, To set the 45 stop bolt

Blade Tilt Stops

The table saw features stop bolts that stop the blade exactly at 45° and 90° during blade adjust- ments. The stops have been set at the factory and should require no adjustments. However, we still recommend that you verify the settings.

Tools Needed	Qty
90° Square	1
Combo Square	1
Wrench 12mm	1
Hex Wrench 4mm	1
Hex Wrench 5mm	1
To set the 90° stop bolt:

1.DISCONNECT THE SAW FROM POWER!

2.Position the blade tilt to zero (see indicator on the front of the saw), and raise the blade several inches above the table.

3.Place a machinist’s square against the table and blade so it contacts the blade evenly from bottom to top. Make sure a blade tooth does not obstruct the movement of the square.

—If the blade is 90° to the table when the stop bolt contacts the underside of the table, go to To Set the 45° Stop Bolt.

—If the blade is not 90° to the table, you will need to adjust the 90° stop bolt.

4.Tilt the blade to 20° to access the 90° stop bolt under the table.

5.Open the motor access cover, loosen the jam nut shown in Figures 75 & 76, adjust the stop bolt up or down, and repeat Steps 2-3until the stop bolt contacts the table when the blade is at 0°.

G0605X/G0606X Extreme Series 12" Table Saw

90° Stop Bolt

& Jam Nut

Figure 75. 90° stop bolt and jam nut.

90° Stop Bolt

& Jam Nut

Figure 76. 90° stop bolt and jam nut (table

removed for clarity).

6.Tighten the jam nut.

To set the 45° stop bolt:

1.Repeat Steps 1-3from the previous set of steps using a combo square set to 45°.

—If the blade is 45° to the table when the stop bolt contacts the cabinet, go to To Adjust the Tilt Indicator Arrow.

—If the blade is not 45° to the table go to Step 2.

2.Remove the blade height lock knob and handwheel.

3.Move the blade angle to 30°, or remove the panel on the right side of the cabinet to access the 45° stop bolt.

-49-