5.While an assistant holds the extension table, fasten the front rail to the extension table with three flat head screws, flat washers and hex nuts (Figure 15). Finger tighten for now.
Figure 15. Front rail/table fastener locations.
6.Fasten the rear rail to the extension table with three cap screws, lock washers (outside), flat washers, and hex nuts (inside), as shown in Figure 16. Finger tighten for now.
Figure 17. Leveling main extension table.
8.Repeat the leveling procedure and tighten the fasteners in Figure 16 with a 6mm hex wrench and 12mm wrench.
9.Using a 17mm wrench, tighten the hex bolts shown in Figure 14.
10.Thread a 3⁄8-16 hex nut on each foot and thread the feet into the bottom of the support legs as shown in Figure 18.
Support Leg
Hex Nut | Foot |
|
Figure 18. Foot installed on support leg.
Figure 16. Rear rail/table fastener locations.
7.Level the table and extension table with a straightedge (Figure 17), then tighten the fasteners in Figure 15 with a 5mm hex wrench and 12mm wrench.
G0605X/G0606X Extreme Series 12" Table Saw |