SECTION 4: OPERATIONS
Operation Safety
Damage to your eyes, lungs, and ears could result from using this machine without proper protective gear. Always wear safety glasses, a respirator, and hearing protection when operating this machine.
Loose hair and clothing 
can get caught in machin- ery and cause serious per- sonal injury. Keep loose clothing and long hair
away from machinery.
Keep the blade guard in the down position at all times. Failure to do this could result in serious personal injury or death.
NOTICE
If you have never used this type of machine or equipment before, WE STRONGLY REC- OMMEND that you read books, trade maga- zines, or get formal training before begin- ning any projects. Regardless of the con- tent in this section, Grizzly Industrial will not be held liable for accidents caused by lack of training.
Basic Controls
The basic controls for the table saw are shown in Figure 36. Setting up for a typical operation con- sists of the following three steps:
1.Make sure the blade tilt is correct. If it needs to be adjusted, loosen the blade tilt lock, turn the blade tilt handwheel, and tighten the lock.
2.Set the blade height approximately 1⁄4" higher than the workpiece thickness by turning the blade height handwheel, then lock the blade height in place by tightening the blade height lock.
3.Adjust the fence to the desired width of cut, then lock it in place by firmly pushing the fence lock down until it stops.
Blade Height | Digital |
| Blade Tilt | |
Lock |
| Readout | Lock | |
|
|
|
| Fence |
ON/OFF |
|
|
| Lock |
Blade Height |
|
| ||
Switch |
| Blade Tilt | ||
| Handwheel |
| ||
| Handwheel | |||
|
|
| ||
Figure 36. Basic table saw controls.
4.The digital readout displays the current blade angle when the handwheel is moved and power is connected to the table saw. See Page 50 for setting the digital readout.
G0605X/G0606X Extreme Series 12" Table Saw |