4.Remove all tools and foreign objects from the machine.
5.Connect the tablesaw to the power source.
6.Put on safety glasses and hearing protec- tion, and make sure any bystanders are wearing safety glasses, hearing protection, and are out of the way.
7.Make sure the safety pin is not installed.
8.Keep a finger on the STOP paddle (Figure 31) at all times during the test run.
9.Press the ON button.
—If any problems occur, immediately press the STOP paddle and DISCONNECT THE SAW FROM THE POWER SOURCE. Turn to Troubleshooting on Page 45 and correct the problem before operating the machine further.
G0605X/G0606X Extreme Series 12" Table Saw
—If you cannot easily locate the source of an unusual noise or vibration by yourself, please contact Technical Support at (570) 546-9663.
—If the saw is operating normally, press the STOP paddle. This should stop the saw.
10.Lift the paddle switch and insert the safety pin through the ON button.
11.Press the ON button.
—If the saw starts, immediately press the OFF button and DISCONNECT THE SAW FROM THE POWER SOURCE. The safety disabling feature is not working correctly. Please contact our Technical Support at
(570)546-9663 immediately.
—If the saw does not start, the safety dis- abling feature is working correctly.
-27-
