Rip Fence
To install the rip fence:
1.Locate the fence rail and remove the last nut and washer from each threaded mounting post.
2.Position the three rail bolts in the location holes along the cast iron table and large extension table.
3.Secure the rail by installing the washer and nut that were removed in step 1 to the back- side of the tables. Figure 42 shows the rail installed.
Figure 42. Fence rail installed.
4.Secure the fence scale to the edge of the cast iron/extension table edge with the four M6-1.0 x 30 flathead cap screws from the packing inventory.
5.Slide the rip fence clamping assembly onto the end of the fence rail (Figure 43). Note— The fence clamping assembly will not slide onto the rail if the clamping lever is in the locked position.
Figure 43. Installed clamp assembly.
6.Slide one end of the aluminum fence piece over the mounting track on the side of the fence clamping assembly. Note—The alu- minum fence piece should slide smoothly back and forth. The handle on the top of the clamping assembly rotates to lock the alu- minum fence piece into position (Figure 44).
Lock
Handle
Figure 44. Installing aluminum fence to clamping assembly in upward position.
G0501 Sliding Table Saw |