Grizzly G0501 instruction manual Access panel removed one side Shown
Page 27
8.Remove the shipping brace, shown in Figure 27, from the end of the sliding table.
Figure 27. Sliding table shipping brace.
9.From the end of the sliding table, look inside the sliding table and locate the three attach- ment blocks. These need to be positioned over the attachment holes. The scale bar is an excellent tool for inserting into the table and positioning the blocks.
10.Starting at the middle hole, reach through the dust port opening and stick your finger in the attachment hole. Have your third assistant use the scale bar to push or pull the middle attachment block so that you can align it with your finger.
11.Once aligned, thread one of the large cap screws from the base into the attachment block, but DO NOT completely tighten with the hex wrench until instructed later in this manual.
12.Remove the two access panels from the back of the base unit (Figure 28) so that you can access both of the remaining attachment holes.
13.Utilizing the same procedures from steps 10 & 11, thread the remaining two cap screws from the base into the sliding table attach- ment blocks.
14.Install the sliding table handles and end cap (shown in Figure 29 & 30) with two flat head screws per each, securing from the top of the table.
