Statistics prove that most common acci- dents among table saw users can be linked to kickback. Kickback is typically defined as the
Preventing Kickback
Below are tips to reduce the likelihood of kick- back:
•Never attempt freehand cuts. If the work- piece is not fed perfectly parallel with the blade, a kickback will likely occur. Always use the rip fence or crosscut fence to support the workpiece.
•Make sure the riving knife is always aligned with the blade. A misaligned riving knife can cause the workpiece to bind or stop the flow of the cut, resulting in an increased chance of kickback. If you think that your riving knife is not aligned with the blade, check it imme- diately!
•Ensure that your table slides parallel with the blade; otherwise, the chances of kickback are extreme. Take the time to check and adjust the sliding table.
•Use the riving knife during every cut. The riv- ing knife helps maintain the kerf in the work- piece after it is cut, therefore, reducing the chance of kickback.
•Feed cuts through to completion. Anytime you stop feeding a workpiece that is in the middle of a cut, the chance of binding, result- ing in kickback, is greatly increased.
Protecting Yourself
from Kickback
Even if you know how to prevent kickback, it may still happen. Here are some tips to reduce the likelihood of injury if kickback DOES occur:
•Stand to the side of the blade during every cut. If a kickback does occur, the thrown workpiece usually travels directly in front of the blade.
•Always wear safety glasses or a face shield. In the event of a kickback, your eyes and face are the most vulnerable part of your body.
•Never, for any reason, place your hand behind the blade. Should kickback occur, your hand will be pulled into the blade.
•Use a pushstick to keep your hands farther away from the moving blade. If a kickback occurs, the push stick will most likely take the damage that your hand would have received.
G0501 Sliding Table Saw |