Crosscutting
With the crosscut fence mounted in the forward position (Figure 69), the Model G0501 has the capability of crosscutting full size panels.
Forward Mounted
Crosscut Fence
Figure 69. Crosscutting full size panel.
With the crosscut fence mounted in the rear posi- tion (Figure 70), this machine also has the capa- bility of crosscutting smaller panels.
Rear Mounted
Crosscut Fence
Figure 70. Crosscutting smaller panels.
Lastly, this machine has the capability of cross- cutting workpieces while using the rip fence as a cut-off gauge (Figure 71).
Figure 71. Crosscutting workpieces using the rip fence as a cut-off gauge.
Determine which cutting operation will be best suited for the workpiece to be crosscut.
—If you will be crosscutting full size panels, then skip ahead to “Crosscutting full size panels.”
—If you will be crosscutting smaller panels, then skip ahead to “Crosscutting smaller panels.”
—If you will be crosscutting workpieces using the rip fence as a cut-off gauge, then skip ahead to “Crosscutting using the rip fence as a cut-off gauge.”
G0501 Sliding Table Saw |