Mounting
Shaft
Figure 47. Mounting the crosscut table over the
shaft on the brace.
5.Remove both end caps from the short cross- support and remove one end cap from the long cross-support as shown in Figure 48.
Cross-support
Cross-support
Hold-Down
Assembly
Figure 48. Cross-support assemblies.
6.Loosen the hold-down assemblies that secure each of the cross-supports.
7.Slide the cross-supports into position and secure them by tightening the hold-down assemblies.
8.Place the crosscut fence on the crosscut table so that the locating pins fit inside the guide holes.
9.Using the handles on the crosscut fence, slide the 2 cam lock rods into the crosscut table (Figure 49). Note—Make sure the lock- ing bolts on the crosscut fence are disen- gaged so the locating pins will easily fall into the table extension.
Cam Lock Rod
Figure 49. Cam lock rod (1 of 2).
10.Install the flip stop units in the crosscut fence by unlocking the extension piece and align- ing the clamp bar on the bottom of the flip stop unit to slide it into the fence. The correct order of placement for the flip stop units is shown in Figure 50.
Inside Flip Stop
Outside Flip Stop
Figure 50. Correct order of flip stop unit
placement.
G0501 Sliding Table Saw | -31- |