General Product Information
Figure 6 Remove Liebert XDR from pallet
Two people are required
to remove the module from the pallet and remove the bag
! WARNING
Risk of
Do not leave a Liebert XDR standing unattended on its side or its end without adequate support to prevent it from falling over. The Liebert XDR must be supported at all times or laid flat on protective material until it is installed.
Two properly trained and qualified people are required to move the module.
3.2.4Removing the Liebert XDR from the Pallet
1.Unfold the module bag to expose the Liebert XDR.
2.Compare the serial tag information on the Liebert XDR to the bill of lading information. If the information does not match the product specified, contact your local sales representative.
3.At least two properly trained and qualified personnel may lift the Liebert XDR off the pallet using the four handles and stand it upright, supporting the module to keep it from falling.
4.If the Liebert XDR will not be installed immediately, lay a piece of protective material the length of the module on a flat surface and lay the Liebert XDR on it.
7