Installation
5.0INSTALLATION
5.1Installing the Rack-Mounting Kit onto the Rack
The Liebert XDR module mounts on the rear of the rack using a mounting kit. The mounting kit secures the Liebert XDR's frame to the rack. Two rails are attached to the rear of the rack with M6 x 12 bolts. The number of bolts can vary depending on the rack.
Before beginning to attach the
1.Insert and screw in the M6 x 12mm bolts that shipped with the Rack Connecting Bracket.
2.Tighten the bolts with a 10mm wrench.
5.2Mounting the Liebert XDR on the Rack-Mounting Kit
! WARNING
Risk of
•Read all instructions before beginning.
•Use caution when installing the Liebert XDR on an equipment cabinet, particularly a cabi- net with little equipment installed. Lack of weight in the cabinet could cause it to tip while the Liebert XDR is being installed.
•Two properly trained and qualified people are required to handle the Liebert XDR.
•Do not move a cabinet with a Liebert XDR installed on it.
The
1.Thread one of the provided M6x12 bolts into the top threaded hole of each rail attached to the rack.
2.Use fingers or a 10mm wrench to tighten the bolts, leaving a 1/8"
3.With another person, lift the Liebert XDR by the handles on the sides, match the two keyhole slots near the top of the Liebert XDR frame to the bolts and hang the Liebert XDR on the rack.
4.Thread the remaining bolts through the holes in the frame and into the mounting rails.
5.Tighten all of the bolts snugly with a 10mm wrench.
Figure 11 Liebert XDR mounting locations
Keyhole Slot 
(One on Each Side)
Keyhole Slot (One on Each Side)
Piping is not
Bolt Holes |
|
|
|
|
| Bolt Holes |
|
|
|
| |||
(3 on Each Side) |
|
|
|
| (3 on Each Side) | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
12